832-25DNR

Sioux Chief 832-25DNR Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Sioux Chief 832-25DNR Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Instructions
Set Drain
n
Connect the rough-in xture to the pipe and adjust the Coring
Sleeve to be ush, or slightly below slab level.
n
No need to estimate/anticipate nish oor level at rough-in,
no need to wrap threads or cover top with duct tape.
n
Apply adhesive (silicone) to the Coring Sleeve threads, if
desired, to lock it in place before the slab is poured.
Install/Adjust Finish Fixture
n
Install the Finish Fixture into the Coring Sleeve and adjust
to oor level - from ush*, to 1¼” above the Coring Sleeve.
Extensions are available for additional height.
n
No problem if ooring spec changes after rough-in.Flooring
contractor can make nal adjustments to height and
alignment as necessary for a perfect nish.
n
Apply adhesive (silicone) to the Finish Fixture threads, if
desired, to lock it in place.
*Minimum height with square strainer = "
Remove Coring Plug
n
After rough construction, and before the nish oor is
installed, remove the Coring Plug.
n
The Coring Plug has taken all the job site abuse, protected
the internal threads and prevented debris from entering the
drain lines.
n
Coring Plug is recyclable with all #2 (HDPE) materials.
Perfect Finish
n
The FinishLine allows for a perfect nish, reecting the
professionalism with which it was specied and installed.
n
No job site damage to strainers/covers.
n
No xtures too low or too high.
n
No tilted xtures.
n
No scraping duct tape.
n
No boxing out.
Pour/Finish Concrete Slab
n
Pour and nish the slab ush with the Coring Sleeve.
n
The ush surface makes it easy for concrete contractors to
provide a smooth, at slab nish.
n
No need to be present during the pour to make last-minute
corrections/adjustments.
Correct for Level
n
If the Finish Fixture surface is tilted, remove the
ring/strainer and install FinishLine Shims as needed to bring
low sides up to oor level.
n
Stack multiple Shims if necessary.
/