WARNING:
Risk of shock, do not plug in the unit before assembly is
complete.
Do not exceed the maximum wattage rating. (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Before you light it up, please follow the instruction manual
step by step.
INSTALLATION
1. Place all parts on a smooth, flat surface to protect the finish
until ready to install.
2. Secure the shade (D) by screw (E) using allen (F).
3. Take off the wire protector (A)
4. Stirring the stand (C) to connect it with the lamp body (B)
until tight.
Your installation is now completed. Return power to the junction box
and test the fixture.
CAUTION /ATTENTION: When handling the fixture, do not
apply pressure to the LEDs.
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps
for more details (Fig 3.)
a. Shut off power. Take off the shade (D) by using allen screw
(F) to disconnect screw (E)
b. Remove the acrylic diffuser (O).
c. Remove lamp body (B) from the base (C). Disconnect the
wire by removing wire nut (J) (I) (H)
d. Loosen screw (E) and screwing (G) out.
e. Remove screws (P) to disconnect LED module (Q), and
slightly pull out the LED module with the wire.
f. Reverse steps a-e for installing the new LED module.