44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
1/7
1
2
3
Protemp
™
Plus
Temporization Material
• Remove excess material as
needed.
• Remove interproximal septa.
• Reposition matrix in the mouth
to confirm proper fit.
44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
2/7
4
5
6
7
• Bleed a small amount of mate-
rial through the mix tip before
dispensing in the matrix.
• Discard extruded material.
• Dispense material into the
impression or matrix.
• Make sure to fill from the
bottom up and to always
keep the tip immersed in the
temporary material to prevent
voids.
• (Working time: 40 seconds)
• Seat in the mouth and hold
firmly in place.
44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
3/7
8
9
10
11
• Check setting progress with
excess material.
• Remove from mouth between
1:40 and 2:50 min:sec from the
onset of mixing.
• Leave material in the matrix for
5:00 min:sec.
• This is important to achieve a
smooth and shiny surface.
• Remove oxygen inhibited layer
with ethanol.
44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
4/7
12
13
14
• Finish and polish as needed.
• Cement provisional restoration
using a temporary cement.
• Remove the excess.
44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
5/7
15
16
17
Individualization and
Shape Correction
• Remove any contamination
with ethanol.
• Dispense Filtek
™
Supreme Plus
flowable composite onto a
mixing pad.
• Apply the composite to the
temporary restoration.
44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
6/7
18
19
• Cure each layer separately with
light for 20 sec each.
• Trim the composite with carbide
burs and polish as needed.
44000757615/01 • Format: 101,6 x 152,4 mm • Lieferant: TB
7/7
44000757615/01 (August 2008)
3M ESPE AG 3M ESPE
Dental Products Dental Products
D-82229 Seefeld
-
Germany St. Paul, MN U.S.A 55144-1000
3M, ESPE, Filtek and Protemp are trademarks of 3M or 3M ESPE AG.
© 3M 2008. All rights reserved.
Timetable
0:40 min 1:40 min 2:50 min 5:00 min
Working Time
Setting in the Mouth
Matrix Removed Complete Setting Removal from Matrix,
Finishing
/
