2. Highwood
  3. Hamilton Counter Ht. Deck Chair

Highwood Hamilton Counter Ht. Deck Chair Assembly Instructions

  • Hello, I'm your AI assistant. I've reviewed the user guide for the Adirondack Collection Hamilton Deck Chair. This document provides assembly instructions, including hardware information, and emphasizes important steps, such as not overtightening bolts. I'm ready to answer your questions about assembling this chair.
  • Should I fully tighten the bolts when assembling?
    What size hex key is needed for assembly?
    What type of bolts are used to attach the seat to the back?
For information on Care and Cleaning or to Register your
highwood product, please visit www.highwood-usa.com. PAGE 1 OF 2
TOOLS INCLUDED
5/32" HEX KEY
IMPORTANT!
DO NOT fully tighten the bolts until all bolts are started.
Once all bolts are inserted, go back & tighten all the bolts.
Adirondack Collection
Hamilton Deck Chair
Counter Height
Assembly Guide
HARDWARE INCLUDED
AD-CHCA2
08.17.2021
AQty: 8
1/4"-20 x 1-1/2"
1) Insert (1) "A" Bolt into Lower Hole on Each
Side to Attach Seat to Back. Make Sure the
Back is Fully Upright. Make Bolts Snug, but Do
Not Overtighten.
ABACK
SEAT
B
1/4"-20 x 2"
Qty: 6
C
1/4"-20 x 1-3/4"
Qty: 2
For information on Care and Cleaning or to Register your
highwood product, please visit www.highwood-usa.com. PAGE 2 OF 2
AD-CHCA2
08.17.2021
2) With the Chair Laying on its Left Side,
Attach the Left Leg Assembly to the Seat
using (3) "A" bolts.
3) Attach Left Arm to the Back Support
Using (1) "B" Bolt.
SEAT
LEFT LEG ASSEMBLY
A
BACK SUPPORT
LEFT ARM
4) Attach the Rung Assembly
and Footrest Assembly to the
Left Leg Assembly using (3)
"C" bolts.
5) Flip Chair and Repeat on
Right Side for Right Leg
Assembly.
C
FOOTREST ASSEMBLY
RUNG ASSEMBLY LEFT LEG ASSEMBLY
B A
/