2. BLOTZ
  3. B10-ME-005

BLOTZ B10-ME-005, B10_ME_005 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the Building model Middle East B10-ME-005. This document details how to assemble the model using parts like front and side walls, a roof, and gateway posts. It also mentions using tools like glue and a modelling knife, and techniques for holding parts during drying. I'm ready to answer your questions about the building construction process.
  • What type of glue is required?
    What tool is required to remove parts from the sprue?
    Can sandpaper be used during the construction?
10mm Middle East #5
B10-ME-005
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the front and side walls of the building
plus the roof piece from the sprue.
Glue the roof section to the walls as shown – note the
position of the hatch.
Take the side and back walls.
Glue these to the building as shown.
Glue the building to the base.
Add the side and front walls.
Add the gateway posts.
The completed building.
/