BLOTZ B06-PS-001 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Cooling Tower B06-PS-001. It seems to be a model requiring careful assembly, using parts like the base, supports, rings, and strips. The instructions highlight the need for PVA glue and a sharp knife for assembly. I am ready to answer any questions you might have about this product.
  • What type of glue is needed for assembly?
    What tool is needed to remove parts from the sprue?
    Can sandpaper be used during assembly?
    What can be used to hold pieces while the glue dries?
6mm Cooling Tower
B06-PS-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care
and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Remove the base and lower supports from the
sprue.
Glue them together as shown above.
Add the upper ring, slowly moving round the
supports and guiding them into their respective
holes.
Each strip is formed from the pieces shown above.
Glue them together as shown.
Add three strips to the model.
Then add the top ring. Add each new strip in turn
inserting the base first then easing the upper
end into its holes in the top ring.
The completed model.
/