Philips MCM119/05 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Philips MCM119/05 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
2
User Manual
1
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
FM Antenna MW Antenna Remote Control
User Manual
Quick Start Guide
Quick start guide
USB Cable
MCM119
DB Cable
Pull out the plastic
protective sheet
before use.
MCM119 QUG_Eng 2007.4.20, 10:151
Connect the main set to the left speaker with
the supplied DB cable.
Connect the right speaker to the left speaker.
Connect the MW and FM antennas.
Connect the power cable on the back of the
left speaker.
1
2
3
Tip
See the User Manual for how to
connect other equipment to this
system.
SPEAKER(4
©)
RIGHT
DB15 CONNECTOR
TO MAIN
AC MAINS ~
FM wire
antenna
MW
antenna
Speaker
(right)
Speaker
(left)
DB cable
1
2
4
3
AC power cord
4
MCM119 QUG_Eng 2007.4.20, 10:152
Enjoy
C
Playing a disc
1
2
3
Press OPEN•CLOSEç to open the disc tray and load in a disc,
then press the same button again to close the disc tray.
Make sure the label side of the disc is facing up.
Press ÉÅ to start playback.
To stop playback, press 9.
Setting the clock
1
2
3
4
In standby mode, press and hold DISPLAY/CLOCK on the remote
control for more than 3 seconds.
Press VOLUME +/- (VOL+/- on the remote) repeatedly to select
clock mode.
Press VOLUME +/- (VOL+/- on the remote) repeatedly to set the
hour.
Press VOLUME +/- (VOL+/- on the remote) repeatedly to set the
minute.
Press DISPLAY/CLOCK again to store the setting.
IMPORTANT!
To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO
POWER
2
on the set for 3 seconds or more to switch to normal standby mode
first before proceeding with the procedures below.
5
MCM119 QUG_Eng 2007.4.20, 10:153
Enjoy
C
Programming and tuning to
radio stations
1
2
3
Press TUNER to select the tuner source.
Press PROGRAM for more than two seconds to program all
available stations in order of waveband.
Press í or ë until the desired preset station is displayed.
1
2
3
Insert the USB device’s USB plug into the socket on the set.
Press SOURCE once or more to select USB (or USB on the remote control).
Play the USB’s audio files as you do with the albums/tracks on a CD,
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players (USB 2.0 or
USB1.1), memory cards (requires an additional card reader to work with this Hi-Fi system).
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
C Royal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
Printed in China PDCC-JS/JW-0716
MCM119 QUG_Eng 2007.4.20, 10:154
/