Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-800-227-2960
Tools
Assembly Directions Printed In U.S.A.
REV
93-9501297 -
Page 1 of 3
International Powerway Assembly Into A
Series 9000® Structural Panel System
All electrical installations should be done by a
qualified person in accordance with codes and
regulations applicable at the installation site.
COMPONENT STYLE NUMBERS
98601-I
98602-I
98603-I
98604-I
98605-I
98606-I
98607-I
98608-I
98609-I
Assembly Directions
93-9501297 REV - Page
2 of 3
1. Remove base trim by pushing down on steel tabs at the bottom
extreme ends (in area of glides) and lifting up and out.
2. Lay panel on its side and remove existing pan assembly. Position
and secure new pan assembly with existing hex head bolts.
APPLY PRESSURE
TO STEEL TABS
BASE TRIM
GLIDE PANEL ASSEMBLY
EXISTING PAN ASSEMBLY
HEX HEAD BOLT
EXISTING PAN ASSEMBLY
EXISTING HEX
HEAD BOLT
Assembly Directions
93-9501297 REV - Page
3 of 3
3. Place left end of international powerway assembly
behind panel tab with the right end in front of other
tab. Secure with (2) serrated head type screws.
4. Connect ground wire connector onto base trim
tab. Replace base trim by reversing Step 1.
INTERNATIONAL
POWERWAY ASSEMBLY
SERRATED SCREW
BASE TRIM
GROUND TAB
GROUND WIRE CONNECTOR
/
