CELLULAR DIRECTIONAL ANTENNA KIT
Installation
DoorKing Part Number
1. Mount the antenna so that there is at least 3 feet of clearance in all directions as high as possible and away from any metal that can impede the
signal (Mounting pole not supplied). Note: Direct line-of-sight between the cellular tower and the cellular directional antenna will produce the
strongest signal. Avoid any obstructions that will impede the signal. Typically, the lower the antenna is mounted, the more obstructions that can
impede signal.
2. Point the antenna in the direction of the service provider's cellular tower. This will result in the strongest reception (greatest range).
3. Connect one end of the supplied coax cable to the antenna. Slide the heat shrink tubing and secure it over the connector to protect from weather.
4. Connect the other end of the coax cable to the DKS cellular modules (1800, 1801) external antenna mount being used. Use the heat shrink
tubing and secure it over the connector if necessary.
Note: Antenna may be installed on 1.25”- 2” mounting pole
(not included) and at many angles. Insure antenna is pointing
at cell tower and is vertical with the drip holes at the bottom.
Antenna Signal Strength Note: If checking the signal
strength using a separate signal meter (not provided),
the readings usually appear as a negative number (for
example: -86). The larger the number, the more
powerful the signal (-75 is stronger than -84).
Copyright 2019 DoorKing
®
, Inc. All rights reserved.
Zip Tie
(Not Supplied)
1514-014
DoorKing's Cellular Directional Antenna is designed to increase the range of cellular signals with any DKS cellular modules (1800, 1801) using
“RG58” type antenna connection.
For maximum performance be sure to aim the antenna in the direction of your wireless provider's tower. If you know the direction of your service
provider’s tower, simply point the antenna in that direction. If your unsure of your service provider's tower direction, test the cellular signal
strength with your cell phone in the location where antenna will be mounted BEFORE permanently mounting antenna. Make sure the signal
strength is strong enough or change the antenna mounting location to achieve a strong signal.
Caution: Keep the antenna and mounting pole away from overhead electrical wires. Electrocution can result!
120 S. Glasgow Avenue
Inglewood, California 90301
U.S.A.
Cellular System
TELEPHONE ENTRY SYSTEM
HOLD TO SCAN
OPERATING INSTRUCTIONS
Use “A to ” Buttons to Locate
Name and Code Number on Display.
Names are In Alphabetical Order.
To Call, Enter Code Number on
Keypad or Press “Call” Button. If
Line is Busy, Press “#” or “Call” to
Hang Up. Try Again.
Enter on Open Display and Tone.
1.
2.
3.
Entry System
1514-066-A-7-19
Drip Hole
Drip Hole
Heat Shrink
Tubing
Coax
Cable
Point at Your Provider’s Cellular Tower
Do Not
Over
tighten
