METAL OUTDOOR ENCLOSURE FOR RF RECEIVER
8057-066-A-3-16
DoorKing Part Number
8057-110
Copyright 2016 DoorKing, Inc. All rights reserved.
Metal outdoor enclosure that is lockable to secure and help protect RF receiver from the elements. Includes (4) four screws to
mount RF receiver inside box and (2) two 90° “F” connectors. The RF receiver, antenna kit, all conduit and coax cable are NOT
included.
3/4” Conduit and watertight
conduit fittings (Not included)
90° “F”
Connector
Antenna (Not included)
18” Coax Cable (Not included)
“F” Connector
(Not included)
90° “F”
Connector
Knockout
Knockout
4 Receiver
Mounting
Screws
Mount box to wall using the
4 existing holes with
appropriate hardware (not
included). DO NOT drill any
extra holes in the box. This
will help protect the receiver
from the weather.
Note: Make sure antenna is
NOT surrounded by metal
and is in free air as high as
possible above the ground.
Remove protective cover with rubber washer and discard when mounting
antenna directly on top of metal box.
Note: The protective cover can remain in place when mounting the antenna
away from the box (15 ft coax cable antenna kit P/N 1514-073) to help keep
the box sealed up from the weather by running the coax cable through the
conduit if desired.
Input Wiring
Output Wiring
120 S. Glasgow Avenue
Inglewood, California 90301
U.S.A.
-
1
DKS Outdoor Enclosure User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
DKS 8057 Receiver User manual
-
-
-
-
DKS 8040 Receiver User manual
-
DKS MicroCLICK 8059 User manual
-
-
-
-
