Angelo Decor Orb Fountain Operating instructions

Orb Fountain with LEDs

59-4019-6

Installation and Assembly Instructions

Read these instructions carefully before beginning installation and assembly.

Carefully unpack the carton, and arrange all of the parts in the working area.

Insert tubing and light cord in the

opening at the top of the orb. Feed the power cord for the lights and the tubing through the access hole in the insert plate, as shown

Place the pump inside the

reservoir. Feed the light and

pump cords down through the

cord pipe.

Align the pump cord and the power cord for the lights along the groove,

and feed the power cord down through the cord pipe at the base of the

fountain.

Install the cord seal, as shown.

Insert the cord seal into the cord pipe, as shown. Set the pump to the desired

power level. Connect the tubing to the pump.

The insert plate should rest on the

lowest lip, as shown. Insert the top section of the fountain. The

insert plate should rest on top lip as shown.

Connect the power cord for the lights to

the transformer. Insert decorative rocks as desired.

The final assembly

should look like this

Fill the reservoir with clean water, and plug the power cord into a grounded outlet that is equipped with GFCI protection.

It is recommended that the bowl be kept 3/4 full of water in order to avoid burning out the pump.

For best results and longer life, keep the fountain clean. Use a soft cloth and mild soap on a regular basis.

This fountain should be stored during the winter, because water that is left to freeze in the reservoir may cause cracking. Disassemble the

fountain, remove the pump and all water, and store it in a garage or shed.