ITC Vi VPH Desktop Phone Charger Installation guide

Brand: ITC

Model: Vi VPH Desktop Phone Charger

Type: Installation guide

ITC Vi VPH Desktop Phone Charger offers both wireless and wired charging options for various devices. It provides up to 10W wireless charging, a USB-A port with 5V/2.4A/12W output, and a versatile USB-C port capable of delivering 5V, 9V, 12V, and 20V at 3A, with a maximum output of 60W. The clamp mount version allows for flexible placement on work surfaces, making it a convenient charging solution for offices or other workspaces.

3030 Corporate Grove Dr.

Hudsonville, MI 49426

Phone: 616.396.1355

itc-us.com

For warranty information please visit www.itc-us.com/warranty-return-policy

DOC #: 710-00227 • Rev A • 09/29/23

1. Desktop Version:

Place in desired location on the desk and plug the charger

into the power supply. Plug the other cord into the power

supply and then plug into the wall.

PARTS NEEDED:

Desktop Phone Charger Power Supply

2. Clamp Mount Version:

Select location and place the charger portion on top of the

work surface. Slide the bracket and knob under the surface

and tighten until secure to the surface.

Plug the charger into the power supply. Plug the other cord

into the power supply and then plug into the wall.

INSTALLATION INSTRUCTIONS

Vi™ Desktop Phone Charger

Part#: VPH

Page 1 of 1

IMPORTANT SAFETY INSTRUCTIONS

Interior use only.

Electrical ratings:

24V AC | 1.2A

Charging Capacity: Wireless: Up to 10W

USB-A - 5V / 2.4A / 12W

USB-C - 5V, 9V, 12V, 20V / 3A / Max 60W

FCC Statement:

This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modiﬁcations not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

FCC Radiation Exposure Statement

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The equipment should be installed and operated with minimum dis-

tance 15cm between the radiator & your body.

FCC VOC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a partic-

ular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Only radiated measurements are used to show compliance with FCC limits for fundamental and spurious emissions.