3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • 710-00217 • REV A 07/26/22
Addressable Luna Extended Length
Flex Light Install Instructions
(Part #: RNLL12AR-30012-17)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
Please visit www.itc-us.com for warranty info
INSTALLATION CONSIDERATIONS:
• Unroll the entire length before installing.
• Work the light into the channel going 6” at a time. The light should go into the channel pretty easily by just thumbing it in.
• Do not use any roller as that may cause damage to the LED circuit.
PARTS/TOOLS NEEDED:
Flexible Light
Mounting
Channel
(purchased separately)
Power Drill
(not provided)
Butt Splice
Connectors
(not provided)
#4 Flat Head Screws
(not provided)
Screw Mount TrackAdhesive Mount Track
1. Determine the installation location and install the track by either taping or screwing in place. Install the light in the track by gently
rocking it back and forth. Refer to installation tips above to ensure a successful installation.
Installing Light
2. Wire the light based on the wiring diagram.
Note: Lengths over 200” must be powered
from both ends.
Addressable Flex Light
Addressable
RGB Controller
Black (-)
Orange (D)*
Red (+)
12V DC (+)
Black (-)
Incoming
12V DC Power
Fuse
*Data line
Black (-)
Red (+)
3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • 710-00217 • REV A 07/26/22
3. Please review the considerations below to ensure a successful installation.
Only bend the wireDo not bend right at solder joint
Do not horizontal bend to a radius of less than 11.8”
R11.8”
Do not bend flexible light at 90° Do not bend to a radius of less than 1/2”
R0.59”
Do not axial bend to the height
of more than 0.312” within 0.78”
segment
0.78”
Less than 0.312”
Do not twist more than 90° over the
length
of one 24V segment / Two 12V segments
(4” total length)
4”
Axis
*RNLL flexible lighting cannot be field cut. Field cutting the light will void the warranty.
/
