2. Belluscura
  3. X-PLOR2
X-PLOR2

Belluscura X-PLOR2 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Belluscura X-PLOR2 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CARTRIDGE REPLACEMENT

By:
Removing Cartridge.
Cartridge Replacement
PART 1

Turn off the X-PLOR® by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLOR.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLOR
from the carrying bag,
if applicable.
Place the X-PLOR on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLOR
and throw away.
Turn sheet over to continue to step 2.
11
33
55
22
44
66
By:
Dust Cap

Installing Cartridge.
Cartridge Replacement
PART 2

XPLOROxygen.com
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLOR so it is fully inside.
Connect charged battery
to the X-PLOR.
Insert new cartridge top first into the
X-PLOR. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLOR as soon as
the used cartridge is removed.
The cartridge pull handle
should lay flat once the cartridge
is secured.
Turn on the X-PLOR by pressing the
power button for 2 seconds. Set the
flow setting to your prescribed setting
and use normally.
11
33
22
44
6655
LBL 5026-03
By:
©2022 Belluscura LLC. All Rights Reserved.
Power Button
/