CARTRIDGE REPLACEMENT
By:
Removing Cartridge.
Cartridge Replacement
PART 1
Turn off the X-PLOR® by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLOR.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLOR
from the carrying bag,
if applicable.
Place the X-PLOR on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLOR
and throw away.
Turn sheet over to continue to step 2.
11
33
55
22
44
66
By:
Dust Cap
Installing Cartridge.
Cartridge Replacement
PART 2
XPLOROxygen.com
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLOR so it is fully inside.
Connect charged battery
to the X-PLOR.
Insert new cartridge top first into the
X-PLOR. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLOR as soon as
the used cartridge is removed.
The cartridge pull handle
should lay flat once the cartridge
is secured.
Turn on the X-PLOR by pressing the
power button for 2 seconds. Set the
flow setting to your prescribed setting
and use normally.
11
33
22
44
6655
LBL 5026-03
By:
©2022 Belluscura LLC. All Rights Reserved.
Power Button
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
XPLORoxygen X-PLOR User guide
-
Hilti 3586412 Installation guide
-
Braven Vale User manual
-
CipherLab CP60 Reference guide
-
Miller WT-1530 Owner's manual
-
-
LG PE-43A82T Owner's manual
-
Naxa NPB-274 Owner's manual
-
Remington Power Tools BGS48A User manual
-
Star Micronics Radix User manual
