vikings MCG-S1 Installation guide

MCG-S1
Brand
vikings
Model
MCG-S1
Type
Installation guide
Updated 2021-10-05
QUICK INSTALLATION GUIDE
MCG-S1 / MCG-S2 series
Ethernet Media Converter
Overview
This Media Converter is designed to convert 10/100/1000Mbps Ethernet data
over inbuilt fiber (MCG-S1) or selectable SFP module (MCG-S2). Fiber port
automatically detects 100Mbps and 1000Mbps network speeds.
Package Contents
MCG-S1 or MCG-S2 Converter x 1
5VDC Power Adaptor x 1
Velcro tape x 1
This Quick Installation Guide x 1
Installation
1. To install Media Converter on a wall or other surface, you can use included
Velcro tape. Clean the surfaces before applying the tape.
2. Connect your network device to the RJ45 Ethernet port with a network cable.
3.
For MCG-S2 insert the appropriate and matching SFP module into the SFP
port. For MCG-S1 and MCG-S2: connect the fiber cable to fiber port.
4. Connect included power adaptor to media converter and plug the power
adaptor to your wall-socket outlet (100-240VAC).
5. After the device is powered on, the PWR indicator will be on. If the indicator
is not on, check the power adaptor and its connection. If all cables are
correctly connected, the indicators will lit as per LEDs status.
LEDs status
LED Color Indication
PWR Red Lit when unit is powered
TX Green
Steady lit when network connection is established on
RJ45 port, flashing when transmitting or receiving data
on RJ45 port
FX/ACT Yellow
Steady lit when network connection is established on
fiber port, flashing when transmitting or receiving data
on fiber port
Contact information
Vikings Technology Co. LTD.
www.vikingstechnology.com
support@vikingstechnology.com
  • Page 1 1

vikings MCG-S1 Installation guide

MCG-S1
Brand
vikings
Model
MCG-S1
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents