Task Force Tips XGC38VL-PL Operating instructions

XGC38VL-PL
Task Force Tips
Brand
Task Force Tips
Model
XGC38VL-PL
Type
Operating instructions
©Copyright Task Force Tips LLC 2021 1 LIY-520 November 1, 2021 Rev00
TASK FORCE TIPS LLC
MADE IN USA · tft.com
3701 Innovation Way, Valparaiso, IN 46383-9327 USA
800-348-2686 · 219-462-6161 · Fax 219-464-7155
G-Force
To install the XGA-RP to the circuit board in the Control Box:
Installation Instruction
Connector Wiring for XGA-RP
Extend-A Gun RC Panel Mount Push Button Operator Station
WARNING
It is the responsibility of service technicians to ensure the use of appropriate protective clothing
and equipment. The chosen protective clothing and equipment must provide protection from
potential hazards users may encounter while servicing equipment. Requirements for protective
clothing and equipment are determined by the Authority Having Jurisdiction (AHJ).
NOTICE
Always disconnect power before installing or servicing electrical components. Failure to do so
could cause damage to the circuit boards.
1. Loosen 6 screws on the
top of the Control Box to
remove the lid.
2. Loosen the strain relief
fitting on the far left,
with engraved markings
PUSH BUTTONS
(OPTIONAL).
3. Remove the strain relief
cap and push the rubber
plug out of the fitting from
the back side.
4. Feed the crimped ends of
the cable through the
strain relief fitting.
5. Push the crimped ends of
the wires into the
connector in the positions
shown.
Push the pins until they
click into place.
6. Plug the connector into the
board header labeled
“buttons”. Push the connector
until it clicks into place.
7. Position the cable in the
fitting so the yellow cable
jacket is just visible inside
the box.
Tighten the strain relief
fitting until snug.
8. Replace the Control Box
lid and secure by
tightening the 6 screws
loosened in Step 1.
Before tightening the lid screws,
ensure that the gasket is
properly seated and there are no
wires pinched between the box
and the lid.
For questions regarding this
installation instruction, the
contact TFT Service
Department at
800-348-2686 or tft.com
NOTICE
  • Page 1 1

Task Force Tips XGC38VL-PL Operating instructions

XGC38VL-PL
Task Force Tips
Brand
Task Force Tips
Model
XGC38VL-PL
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents