Cumberland Pressure sensor Owner's manual

891-00589 REV00

Pressure Sensor

This pressure sensor is intended for gas or liquid measurement in agricultural and industrial

environments. The sensor's measuring range of 0-100 psi is ideal for watering applications and

suitable for other gas or liquid applications in livestock houses. The sensor is protected by a sturdy

stainless steel housing and provides a 4-20 mA output. Requires EDGE software version 2.5 or higher.

Item

Description

Lbs

Kgs

028-00694 (EDG-149)

PRESSURE TRANSMITTER - GAS/LIQUID

0.5

0.23

To complete these steps, you must have set-up privileges.

CONFIGURING EDGE SOFTWARE FOR PRESSURE SENSOR:

1. Select the Equipment Congifuration Icon.

2. Select the room you wish to add the equipment to.

3. Scroll down and select Generic Input.

4. Select the Add or Copy equipment button.

891-00589 REV00

5. Name the Sensor as you choose and then select the Signal Type, Units, and Precision as shown

below.

The Expansion Box, Slot, and Input are site-specific and determined by where the sensor wiring is landed.

6. Select the Home Screen Icon.

7. Scroll to the room you added the equipment to and select the generic input tile.

8. Select the sensor and check the “Show on tile”. Up to 3 inputs can be shown on a tile per room.

891-00589 REV00

CONFIGURING EDGE SOFTWARE ALARMS FOR PRESSURE SENSOR:

1. Select the Setup Icon.

2. Select the room you wish to add the alarm to.

3. At the bottom of the page select the Alarm button.

4. Select Generic Input.

5. Select the sensor you want to add the alarm to.

6. Select Use low and/or Use high alarm and enter the specific alarm threshold you desire.

7. Adjust the “Recognition time”.

8. Select “Main alarm relay” if you would like this alarm to trigger the alarm system.

9. If configured, the system can trigger an EDGE “Alarm relay” to perform and secondary function

that responds to the alarm. An example of this might be closing a relay to shut off the water

supply based on the low alarm threshold.

Please contact your District Manager if you have any questions.