2. Telongo
  3. LX320

Telongo LX320, LX320-C2 Installation guide

  • Hello! I've reviewed the user manual for the LX320-C1 and LX320-C2 telephone dialers. This document describes how to install and program these devices, including setting the password, hook flash settings, and restoring default settings. I am ready to answer your questions about the dialer and its functions.
  • What type of phones is the LX320 compatible with?
    How do I enter program mode?
    How do I exit program mode?
Installation
InstalltheLX320asshowninthebelowdiagram.TheLX320isonlyworkonstandardanalog
phones.Donotinstallthedialerondigitaltypetelephones.TheLX320istelephoneline
poweredandhasnon‐volatilememorysoitwillnotloseitsprogramwhenunpluggedfromthe
telephoneline.
ModelLX320‐C1
ModelLX320‐C2
Connecttowalljack
Connecttotelephone
Programregisterquickreference
Register Registerdescription Validentries Default
01 ProgramPassword 1234567890*,#1 54321*
02 HookFlashTriggerDigitString 1234567890*,#1 empty
03 FlashHookIntervalinMilliseconds 50‐ 9999 500
88 Restoredefaultsettings
99 Exitprogramming
Enteringprogrammode
1
Liftthetelephonehandsetdialthedefaultprogrammingpassword54321*,youwillhearone
beep.Youarenowinprogrammodeandcanenteranyvalidprogramregister.Ifyouenterthe
passwordincorrectlyyouwillhavetohangthephonethenliftthehandsetagainandenterthe
programpasswordagain.Toexitprogrammodedial99waitforbeepandhangup.Atanytime
youhere4beepsthismeansaprogramentrywasincorrect.
Programmingsemantics
WhenprogrammingtheLX320usethefollowingsemantics:Firstyouhavetobeinprogram,this
isexplainedinsection“Enteringprogrammode”.
1.Dialregisternumberandyouwillhear1beep.
2.Dialprogramdata.
3.Dial##tosaveregisterentryandyouwillhear2beeps.
Example:02beep*1##beepbeep.ThisprogramstheLX320togenerateaflashhookwhen*1
isdialed.
Specialcharacterentries
Toprograma#inaregisteryouhavetoenteritasfollows"#1"
Register01programpassword
Withthisregisteryoucanchangethedefaultprogrampassword.
Scenario:Youwanttochangethepasswordto5*78*
Howto:
⦁ 01beep
⦁ 5*78*
⦁ ##beepbeep
Register02HookFlashTriggerDigitString
WhenthisregisterisprogrammedwithanumbertheLX320willsendahookflashwhendialed
numbermatcheswhatisprogrammedinthisregister.Scenario:YouwanttheLX320to
generateahookflashwhen*1isdialed.
Howto:
2
⦁ 02beep
⦁ *1
⦁ ##beepbeep
Register03HookFlashIntervalinmilliseconds
Programthedurationofhookflashthatyourequire.
Scenario:Youwanthookflashdurationof750milliseconds.
Howto:
⦁ 03beep
⦁ 750
⦁ ##beepbeep
Register88Restoredefaultsettings
WiththisregisteryoucanreloadtheLX320defaultsettings.Important:Afteryouenter88##
youmustwaitforthe2confirmationbeeps.Donothangupbeforehearingthe2confirmation
beeps,doingsomaycorrupttheLX320memory.
Howto:
⦁ 88beep
⦁ ##beepbeep
Register99Exitprogramming
Dialing99willexitprogrammode.
3
/