~This device is not designed to be used by people (including children) with
limited physical, sensory or mental capabilities or people without adequate
experience and/or understanding, unless they are supervised by someone
responsible for their safety or are instructed by them on how to use the
device.
~Children may not play with the device.
~Keep the device out of the reach of children.
DANGER from battery
~DANGER OF EXPLOSION!
~Do not cover the device while charging the battery.
~Only charge the device in a dry environment.
~The device contains a lithium polymer battery.
- The battery cannot be removed.
- Do not open the device.
- Completely dispose of the device.
~Do not expose the device to direct sunshine or heat. The ambient tempera-
ture should not be lower than 50 °F or higher than 104 °F.
~Only charge the battery with the original accessory (USB charger cable).
WARNING! Risk of material damage
~If you notice any irregularities (e.g. unusual noises, strange smells or smoke
developing) turn the device off immediately. Do not use the device any
more.
~If the device is moved from a cold location to a warm location, condensati-
on may form in the device. Leave the device switched off for a few hours.
Bluetooth Mini Speaker SBL 4.1 A1
Thank you for your trust!
Congratulations on your new Bluetooth mini speaker.
For a safe handling of the device and in order to get to know the entire scope
of features:
• Thoroughly read these operating instructions prior to initial
commissioning.
• Above all, observe the safety instructions!
• The device should only be used as described in these operating
instructions.
• Keep these operating instructions for future reference.
• If you pass the device on to someone else, please include these
operating instructions. The operating instructions are a part of
the product.
We hope you enjoy your new Bluetooth mini speaker!
The Bluetooth® word mark and logos are registered trademarks owned by Blue-
license.
All other names and trademarks are the property of their respective owners.
Intended purpose
This is a consumer electronics device. The Bluetooth speaker is intended for
playing sound from audio devices. The device has a hands-free function.
The device is designed for private, domestic use. This device may not be used
for commercial purposes.
Safety information
Warnings
If necessary, the following symbols and warnings will be used in these opera-
ting instructions:
DANGER! This symbol, in combination with the note "Danger" means
a high risk. Failure to observe this warning may result in injury to life
and limb.
WARNING! This symbol, in combination with the note "Warning"
means a moderate risk. Failure to observe this warning may result in
injury or serious material damage.
DANGER! Risk of electric shock!
CAUTION: low risk: Failure to observe this warning may result in minor injury
or material damage.
NOTE:
device.
DANGER for children and people with disabilities
~Packing materials are not children's toys. Children may not play with the
packing material. There is a risk of suffocation!
US / English ~Protect the device against damage, e.g. from:
- drips and splashes of water
-
- impacts and similar violent effects
~Protect the cable against damage, e.g. from:
- sharp edges
- hot places
- clamping or crushing
~Do not use any astringent or abrasive cleaning agents.
~
carried out by a specialist workshop or the Service Center.
Items supplied
1 Bluetooth speaker
1 USB charger cable (Type A on Micro USB)
1 3.5mm (0.14 inch) stereo jack cable
1 Operating instructions
In the case of incomplete delivery, please contact the responsible service center
of the manufacturer (see „Warranty and Service“).
Overview
345
6
7
8
9
USB charger cable for Micro
3.5mm (0.14 inch) stereo jack
cable
3 Micro USB port
4 Jack socket
5 Speaker
6 Button
7 LED
8 Button
9 Button
Microphone
OFF/ON switch
•
•
• Check that the device is undamaged.
Charging
DANGER from battery!
~Do not cover the device while charging the battery.
~Only charge the device in a dry environment.
NOTES:
• Charge the battery fully before using the device.
• At a battery capacity of less than approx. 10%, repeated audio signals will
sound until the battery is empty and the device automatically switches itself
off.
•
to operate the device during the charging process, however, this extends the
charging time.
1. Plug the Micro USB connector of the USB charger cable into the Micro
USB port of the device.
2. Connect the USB-A connector of the USB charger cable e.g. to the USB
port of a PC or to a USB power unit (not included in scope of supply). The
LED glows red and turns off when the battery is fully charged.
Operation
Button functions
NOTE: it is possible that not all of the functions will be supported by all cell
phones.
Button Function
While playing:
• Short press: Pause / Play
During a call:
• Short press: Accept / end call
• long press: reject call
• Short press: Next song
• Keep pressed: Increase volume (acoustic signal goes off at
maximum volume)
• Short press: Beginning of the song
• Short press 2x: Previous song
• Keep pressed: Decrease volume (acoustic signal goes off at
minimum volume)
LED indicators
LED indicator Function
LED glowing red The battery is being charged
(other simultaneous displays are possible,
but they do are not illuminated so brightly)
in blue
Device attempting to connect to the most
recently paired device
to establish a Bluetooth connection (pairing)
Bluetooth connection is established
LED glowing green Connector of the 3.5mm (0.14 inch) ste-
reo jack cable is plugged into the jack
socket
(no Bluetooth connection)
Establish a Bluetooth connection
NOTES:
•
• After turning it on, the device automatically will try to reconnect to the last
paired device or to establish a new connection.
• Please note that the connection process may vary slightly depending on
the device and the software used.
• The device will switch off if no Bluetooth connection can be established
Operating instructions
US / English
ID: SBL 4.1 A1_16_V1.5
TOZ279395_BT_Mini_Lautsprecher_EN_fuer_US.indd 1-9 28.06.16 15:49
Cleaning / storing
DANGER! Risk of electric shock!
• Disconnect all cable connections.
• Switch on the device using the "switch.
• Clean the device with a slightly damp cloth. Do not use solvents, spirits, thin-
ners etc., as they can damage the surface of the device.
• When not using the device, store it in a place where neither high temperatu-
res nor moisture can affect it.
Disposal
DANGER from battery!
The device contains a lithium polymer battery.
• The battery cannot be removed.
• Do not open the device.
• Completely dispose of the device!
This appliance must not be disposed of as household garbage.
If the electrical appliance is no longer be used, it must be handed over to the
relevant local public waste authorities for disposal.
As a rule, these waste disposal authorities run special reception units for electri-
cal appliances (recycling centers, materials recovery centers etc.).
Packaging
The packaging is made from recyclable materials. Dispose of the packaging
sorted by materials. When disposing of the packaging, make sure you comply
with the environmental regulations applicable in your state/city.
Troubleshooting
If your Bluetooth speaker fails to function as required, please try this checklist
WARNING! Risk of material damage!
Do not attempt to repair the device yourself under any circumstances.
Fault Possible causes / Action
No function • Is the battery empty?
•
No Bluetooth
connection
• Is the Bluetooth function of the audio device active?
• Did you switch off the device?
• Is there a plug in the jack socket?
Music cannot
be played via
Bluetooth
• ?
• Is the volume set too low?
• on
the Bluetooth loudspeaker?
Model: SBL 4.1 A1
Power rating:
Bluetooth: Bluetooth v4.1
Socket:
Battery:
USB port:
Weight:
Ambient conditions: 50 °F to 104 °F
FCC hints
FCC Warning Statement
compliance could void the user's authority to operate the equipment.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-
- Increase the seperation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warranty and Service
Dear Customer,
thank you for deciding to purchase one of our products. We give three years'
warranty from the date of purchase (invoice date) in the event of defects in the
quality of the product.
Distributor: Lidl US LLC.
Arlington, VA22202
Country of origin: China
(free of charge in USA)
NOTES:
• For some cell phones, you have to choose Bluetooth as audio source when
accepting a call.
• It is possible that not all of the functions will be supported by all cell phones.
1. Press the button to accept the call.
2. Adjust the volume during the phone call using the buttons
/
3. Short press the button during the phone call to end the call. If you
have accepted the call while music was playing, the song will continue to be
played after ending the call.
Playing music using the cable
NOTE: if there is a device connected via a cable, this connection has priority
over the Bluetooth connection. Any existing Bluetooth connection will be
interrupted. Phone calls can no longer be made wirelessly.
1. into
the headphone socket of the sound source (e.g. MP3 player, telephone) and
the jack socket on the device.
2. Switch on the sound source.
3. Switch on the device using the "switch. The is illuminated in
green.
4. Press PLAY on the sound source. The sound is reproduced via the speaker.
5. Set the volume on the sound source to the maximum level and adjust the vo-
lume on the device using the buttons / . The song must be chosen
via the sound source.
•
the switch "before being able to switch it back on again.
• With moderate volume settings, the device may be used for a period of
1. If necessary, remove the plug of the 3.5mm (0.14 inch) stereo jack cab-
le from the jack socket.
2. Switch on the device using the " switch. An acoustic signal
sounds. The LED
audio signal sounds. Then the LED
3. Switch on the audio device (e.g. smartphone) and start the Bluetooth
4. Establish a connection to the Bluetooth speaker on the audio device. Both
devices are now interconnected. The LED
in blue and an audio signal sounds.
NOTE:
way, it’s possible that a new manual connection will not be required while
the Bluetooth function is active.
5. Now play a song on the audio device. The sound is reproduced via the
loudspeaker.
Accepting calls
If the device is connected to a smartphone, it is possible for you to accept
calls. The ring tone is reproduced via the loudspeakers and the music
playback is interrupted.
TOZ279395_BT_Mini_Lautsprecher_EN_fuer_US.indd 15-18 28.06.16 15:49
/
