2. Thermo Fisher Scientific
  3. Owl C2-S Gradient Gel Caster

Thermo Fisher Scientific Owl C2-S Gradient Gel Caster Operating instructions

  • I've reviewed the user manual for the C2-S Micro Gel Caster. This document outlines the step-by-step process of gel casting using the Owl Micro Gel System Model. The manual details how to place the glass slide, pour the agarose solution, use the comb, remove the slide after solidification, and prepare it for running the gel in the buffer chamber. I'm ready to answer any questions you have about these procedures.
  • What size glass slide is used with the caster?
    What is the next step after the agarose solidifies?
    Where do I place the glass slide after removing it from the caster?
Part of Thermo Fisher Scientific
Thermo Scientific C2-S Micro Gel Caster
Gel Casting Using the Owl Micro Gel System Model
1. Place the 2" X 3" glass slide onto the
base of the caster.
2. Prepare and pour agarose solution
onto the glass slide in the gel casting
tray. Place comb into the slots located
on the slides of the caster.
3. Once completely solidified, push one
finger up through the hole in the center
of the caster and remove the glass
slide.
4. Place the glass on the platform of the
buffer chamber. Add buffer, load
samples and run the gel.
© 2012 Thermo Fisher Scientific Inc. All rights reserved. All trademarks are the property of Thermo Fisher Scientific Inc. and its subsidiaries.
Specifications, terms and pricing are subject to change. Not all products are available in all countries. Please consult your local sales representative
for details.
>> For more information, visit: www.thermoscientifc.com/owlsci
/