2. George Kovacs
  3. P1336-665-L

George Kovacs P1336-665-L User manual

  • Hello! I've reviewed the installation instructions for the Minka Group LED Chandelier/Pendant Lights, specifically models P1336-665-L and P1337-665-L. This document provides detailed guidance on how to hang the fixture, connect the wiring, and complete the installation. It also includes important warnings, such as shutting off power before beginning. I'm ready to answer any questions you have about the installation process.
  • What should I do before starting the installation?
    How do I attach Mounting Plate?
    What should I do if my outlet box does not have gound wire?
INSTALLATION INSTRUCTIONS
FOR P1336-665-L/P1337-665-L
FOR LED Chandelier/Pendant Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BRE AKE R.
AV E R T I S S E ME N T ! C O U P E R L E C O U R A N T A U N I V E A U D ES F U S I B L E S OU D O D I S J ON C T E U R
Fig. 2
HANGING THE FIXTURE
1. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove old
fixture including the mounting hardware
SUGGESTED INSTALLATION (Fig. 1,3)
3. Open the box, the fixture is placed like Fig. 1. Align (I)
into (H) and fix using screw (J).
4. Attach the Mounting Plate (B) to the Junction box (A)
using screws (C) (Screw Size: 8-32*1/2”L) as the
direction on Fig. 3.
5. Determine length desired and thread Rod (F1,F2) to
housing (N), then place the Canopy (G) over the Rods
(F1) and connect swivel (D) to Rods (F1). Note:
remove the nipple if installing with one 6” rod only.
6. Connect the canopy with the mounting back plate (B)
and secure with Mounting screws (E).
CONNECTING THE WIRES (Fig. 2,3)
7. Cut the extra wire. Connect the driver input wires (Red
and Black) with canopy as shown in Fig.3, making sure
that all wires connectors (O) are secured.
8. Connect the driver output wire with fixture wire as
shown in Fig.2, making sure that all wire connectors
(P) are secured.
9. If your outlet box has a green or bare copper ground
wire, connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the
mounting plate (B) using the green screw provided.
After wires are connected, tuck them carefully inside
the junction box (A).
COMPLETING THE INSTALLATION (Fig. 1)
For slope ceiling application, rotate swivel at the top of
the stem to ensure luminaries is aiming down (Fig. 3).
Your installation is now complete. Return power to the
junction box and test the fixture.
CAUTION /ATTENTION: When handling bracket, do not
apply pressure to the LEDs. Hold the metal parts.
Fig.1
Set#
- Mounting plate
- Ground screw
- Mounting screws*2pcs
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
Page: 1/2
Fig.3
Page: 2/2
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.
.
/