2. BLOTZ
  3. B28-ST-138

BLOTZ B28-ST-138 Assembly Instructions

  • Hello! I've reviewed the instruction manual for the BLOTZ Statue Base B28-ST-138. It details how to assemble the base using glue, sandpaper, and a modeling knife, which is constructed from several pieces. I'm ready to answer any questions you have about the assembly process or the components involved.
  • What is required to stick sections together?
    What can be used to clean any joints?
    What is required to remove sections from the sprue?
28mm Statue Base
B28-ST-138
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue the sides to the base shown above, so that they
form an open topped box.
Add the top.
Take the three remaining large pieces from the
sprue.
Glue them together as shown.
Then glue them underneath the section you have
already made. Add the final piece to the top 9as
shown).
The finished Statue base
/