2. RC4WD
  3. Warn 1/24 Zeon 10 Non-Functional Winch Model Kit

RC4WD Warn 1/24 Zeon 10 Non-Functional Winch Model Kit User manual

  • Hello! I've reviewed the instruction manual for the RC4WD Warn 1/24 Zeon 10 Non-Functional Winch Model Kit. This document carefully walks you through each step of assembling the model winch, from threading the line onto the spool to mounting it on a scale bumper. I am here to answer any questions you might have about the process or the components it describes.
  • What is included in the kit?
    Can I use glue for all assembly steps?
    Where is the winch placed on the model?
    What type of screwdriver do I need?
RC4WD Warn 1/24 Zeon 10
Non-Functional Winch Model Kit
Step 1: Insert the long thread through the hole
of the spool, then install the grub screw into
the hole to fix the long thread. Finally, tie the
opposite end of the thread to the hook.
Glue can also be used to do this, but you may
risk making a mess.
Step 2: Place the spool into the winch. Glue can be used to
fix the winch into place.
Step 3: Paste decals onto their designated spots on the winch.
* Due to the small parts of the winch you may have a small gap between the halves.
Dry fit the parts before gluing to determine if fitment will be good.
PN 83439 Ai
PN 83439 Ai
Step 4: Place the winch on the front bumper and secure it
with the M1.4 screws and a Phillips screwdriver.
720 N. Gateway St.
Visalia, CA93291
www.RC4WD.com
[email protected] 100-0102
/