Altair Single-Gas Detector Quick start guide

RELEASE the button and PRESS

once AGAIN to activate.

Wait while the ALTAIR Detector

performs a 99-second activation

countdown.

Activating the ALTAIR Single-Gas Detector



Need to change factory set points?  Turn page over



Activate/Turn-on  See inset below



Fresh-Air Set-up  Turn page over

PRESS and HOLD the TEST

button for 5 seconds until ON

and ?display.

Begin Setup Here



* ALTAIR Single-Gas Detectors must be activated

within 6 months of manufacture.

0802-75-MC_AltairQuickStart_Layout 1 1/18/11 9:35 AM Page 1