2. Computers & electronics
  3. Computer cables
  4. Power cables
  5. Metra
  6. 70-5514
70-5514

Metra 70-5514 Specification

  • Hello! I am an AI chatbot trained to assist you with the Metra 70-5514 Specification. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
©Copyright 2004 Metra Electronics Corporation
1-800-221-0932 www.metraonline.com
INSTALLATION
INSTRUCTIONS
AW-WHFPS/CK-WHFPS
DW-5514
REV. 04/14/06 INST70-5514
KIT COMPONENTS
• Cutting Tool • Tape • Crimping Tool • Connectors
TOOLS REQUIRED FOR INST
ALLATION
STRIP
SPLICE
SOLDER
TAPE
4
FINAL WIRING CONNECTIONS
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray / Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s
specifications.
Make wiring connections using the EIA color code chart shown below and the
instructions included with the head unit. Metra recommends making connections
as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends
of any unused wires to prevent electrical short circuit.
Ford Premium Sound System Harness
to Bypass or Integrate Factory Audio
Components with Aftermarket Audio
Components
70-5513
Amplifier
By-Pass
Cable
Amplifier
By-Pass
Cable
Power
Harness
Amplifier
Integration
Plug
Continued from Page 3
Join the input/output connectors together using the
Amplifier By-Pass Cable.
(Figure D)
6
Unplug the input/output connectors from the factory
amplifier. (Most amps are located in the passenger rear
or behind the dash. Contact Metra’s Technical Support for
further assistance.)
(Figure C)
5
Re-connect the negative battery terminal and test the unit
for proper operation.
7
C
D
70-5514/AW-WHFPS
CK-WHFPS/DW-5514
70-5514/AW-WHFPS/CK-WHFPS/DW-5514
70-5513/70-5514
2
3
1
Disconnect the negative battery terminal to prevent an
accidental short circuit.
1
Unplug the power and output connectors from the factory
radio.
(Figure A)
2
Plug the power and amplifier integration harnesses into
the factory power and output connectors.
4
Splice the wire from the aftermarket radio to the power
and amplifier integration harnesses using the color code
on back cover and the instructions included with the
aftermarket radio.
(Figure B)
3
TO INSTALL AN AFTERMARKET RADIO
WHILE
KEEPING THE FACTORY AMPLIFIER
AND SPEAKERS
(A) Strip wire ends back 1/2"
(B) Twist ends together
(C) Solder
(D) Tape
B
(A) Strip wire ends back 1/2"
(B) Twist ends together
(C) Solder
(D) Tape
B
Re-connect the negative batter
y ter
minal and test the unit
for proper operation.
5
A
A
A
B
(A) Strip wire ends back 1/2"
(B) Twist ends together
(C) Solder
(D) Tape
C
Disconnect the negative battery
terminal to prevent an accidental short circuit.
1
Re-connect the negative batter
y ter
minal and test the unit
for proper oper
ation.
5
Unplug the input/output connectors from the factory
amplifier. (Most amps are located in the passenger rear
or behind the dash. Contact Metra’s Technical Support for
further assistance).
(Figure A)
2
4
Join the input/output connectors together using the
Amplifier By-Pass Cable and cut the cable in half.
(Figure B)
3
Splice the wires in the cable to the wires on the new
aftermarket amplifier using the color code chart on back
cover and the instructions included with the amplifier.
(Figure C)
70-5513
TO INSTALL AN AFTERMARKET AMPLIFIER
WHILE
KEEPING THE FACTORY RADIO AND SPEAKERS
TO INSTALL AN AFTERMARKET RADIO WHILE
KEEPING THE FACTORY SPEAKERS
AND BYPASSING THE FACTORY AMPLIFIER
Disconnect the negative battery
terminal to prevent an accidental short circuit.
1
Unplug the power and output connectors from the factory
radio.
(Figure A)
2
Splice the wire from the aftermarket radio to the power and
amplifier integration harnesses using the color code on the
back cover and the instructions included with the aftermar-
ket radio.
(Figure B)
3
Plug the power and amplifier integration harnesses into
the factory power and output connectors.
4
Continued on Page 4
70-5514/AW-WHFPS/CK-WHFPS/DW-5514
70-5514/AW-WHFPS/CK-WHFPS/DW-5514
70-5514/AW-WHFPS/CK-WHFPS/DW-5514
/