1
© Midmark Corporation 2007
MA777900i
Pediatric Exam Table Installation
Applies to Models:
640 (all)
Special Tools:
level
Language of origin: English
003-1810-00 Rev. (A)
Equipment Alert
Do not lift the table by grasping the upholstered top.
Refer to illustration for proper lifting points.
Shipping Bolt
Leveling Feet (qty: 4)
Shelf Clips (qty: 4)
Digital Scale (qty: 1)
Screws (qty: 4)
Cable Clamps (qty: 2)
AC Adapter (qty: 1)
Step 1: Remove table from skid.
A. Remove three shipping bolts.
B. Carefully lift table off of skid.
(See illustration for proper lifting points).
Style A
2
© Midmark Corporation 2007
ON/ZER
O
O
F
F
kg/lb
kg
lb
B
W
B
-
8
0
0
A
C
L
A
S
S
I
I
I
2
0
0
k
g
/
0
.
1
k
g
4
0
0
l
b
/
0
2
l
b
n
m
a
x
2
.
2
0
C
E
N
T
E
R
L
O
A
D
T
A
N
I
T
A
Battery Size: AA (LR6 Alkali)
Quantity: six (6)
Step 2: Install digital scale.
A. Secure scale bracket to back of table with four screws.
B. Connect cable to digital display.
(Arrow must be facing the front of digital display to connect).
C. Snap cable into cable clamp.
Cable Clamp
Arrow
Step 3: Provide power to digital scale.
Install batteries or connect AC adapter to scale.
*Electrical Requirements
120VAC, 60 Hz, 5W
Cable Clamps
Attention
Two adhesive-backed cable clamps are provided.
These can be used to secure the adapter cable to
the table, wall, etc. (see illustration below).
AC Adapter Conection
Battery
Installation
3
© Midmark Corporation 2007
ON/ZER
O
OFF
kg/lb
kg
lb
BW
B-800A
CLASS III 200 kg/0.1kg 400lb/02lb
n
max 2.20
C
ENTER
LO
AD
T
A
NI
T
A
MA778400i
Midmark Corporation
60 Vista Drive
Versailles, OH 45380-0286
Phone: 937-526-3662
Fax: 937-526-5542
www.midmark.com
Equipment Alert
To ensure proper operation, the table must be level.
Leveling Feet
Qty: 4 (located at each corner)
Step 4: Level the table...
A. Install four leveling feet.
B. Place a level on table top.
C. Adjust leveling feet until table is level.
Shelf Clips
Shelf
Tabs
Step 5: Install storage shelf.
A. Install four shelf clips at desired height.
B. Latch rear lip of shelf into shelf tabs.
C. Lower shelf onto shelf clips.
Step 6: Adjust doors if neceessary.
Depth Adjustment
Turn this screw to move
panel forward / back.
Vertical Adjustment
Loosen this screw on both hinges.
Move door up / down, then tighten screws.
Horizontal Adjustment
Turn this screw to move
panel side to side.
/