1
Flying Copter -X450
Quadcopter Installation
2
Flying Copter -X450
3
1. Fix the aluminum motor mount by M3X10 screws and M3 self fix nut onto the Carbon Plate
4
1. Insert the longest carbon boom into the aluminum motor mount, and fix the boom by using M3X18 screws
Fix the Aluminum motor mount on another side with M3X15 Hex copper pillar and M3X10 screws, then insert the
carbon boom and fix it by using M3X22 screws, fix the other side by using M3X15 Hex copper pillar and M3X10
screws too.
5
After fix well the carbon booms, fix the carbon plate(battery plate) onto the M3X15 Hex copper pillar by using M3
self-fix nut.
About landing skid installation fix the two carbon landing skid by using round aluminum pillar and M3X10 screws
firstly, and install the aluminum motor mount with carbon landing skid by M3X25 screws, then insert the 4 piece of
landing skids onto the carbon booms, installation ready!
6
/
