Rockwell Automation Allen-Bradley 140G-G User manual

Allen-Bradley 140G-G
Brand
Rockwell Automation
Model
Allen-Bradley 140G-G
Type
User manual

Rockwell Automation Allen-Bradley 140G-G is a multi-cable terminal lug designed to distribute power to different loads on a load side of a circuit breaker. It is not intended for use on a line side. With a maximum AWG of 2 and a maximum diameter of 0.31 inches, it can accommodate a wide range of cable sizes. The 140G-G features a screw clamp termination type for secure and reliable connections. Additionally, it has an end cap kit and a terminal cover for added protection.

Rockwell Automation Allen-Bradley 140G-G is a multi-cable terminal lug designed to distribute power to different loads on a load side of a circuit breaker. It is not intended for use on a line side. With a maximum AWG of 2 and a maximum diameter of 0.31 inches, it can accommodate a wide range of cable sizes. The 140G-G features a screw clamp termination type for secure and reliable connections. Additionally, it has an end cap kit and a terminal cover for added protection.

Cu Copper Multi-cable terminal lugs 140G-G, 140G-H, 140G-I, 140G-J
Cu Terminali multicavo
Cu Vorderseitige Anschlüsse für mehrere Kabel
Cu Prises multicâble
Cu Terminales multicable
Bul. 140G/140MG
DIR 1000719R0808 Version 05
WARNUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNING: To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
AVERTISSEMENT: Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
Installation - Installazione - Instalación
Instalação - -
DIR 1000719R0808 Version 05 - 140G-_-MTL63, 140G-_-MTL64
x1
/
x1
/
x1
/
x1
/
x3
x4
x3
x4
/
/
/
/
/
x1
/
x1
/
x1
/
x1
/
/
/
/
x3
x4
x3
x4
140G-G
140G-H
140G-I
140G-J
4p
3p
4p
3p
4p
3p
4p
3p
/
/
x3
x4
x3
x4
/
/
x1
x1
x1
x1
x1
x1
x1
x1
警告：感電事故防止のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。（NFPA70Eの要件に従ってください）
警告：为了防止触电，在安装或维修之前必须先切断电源。安装在合适的设备
箱内。防止接触污染 。符合NFPA70E要求）物
140G-G 140G-I
CLACK
1
140G-H 140G-J
CLACK
1
End
cap kit
Lug
Screw
Terminal cover
LEN GT H dia.
12 m m (0.47" ) 3
L'uso di questi morsetti sull’interruttore lato alimentazione è escluso.
Questi morsetti posso essere installati sull'interruttore lato carico per
distribuire l'alimentazione a differenti carichi
These connectors are not intended for use on a line side.
These connectors can be used on a load side of a circuit breaker to
distribute power to different loads.
Se excluye el uso de estos bornes en el interruptor del lado alimentación.
Estos bornes pueden ser instalados en el interruptor, lado carga, para
distribuir la alimentación a diferentes cargas.
L'utilisation de ces bornes sur le disjoncteur côté alimentation est exclue.
Ces bornes peuvent être montées sur le disjoncteur côté charge pour
distribuer l'alimentation à différentes charges.
Die Benutzung dieser Klemmen auf dem netzseitigen Leistungsschalter ist
ausgeschlossen.
Diese Klemmen können auf dem lastseitigen Leistungsschalter zur
Verteilung der Stromversorgung auf unterschiedliche Lasten installiert
werden.
2
3
4
5
6
1
140G-G
140G-H
140G-I
140G-G
140G-H
140G-J
(2)
DIR 1000719R0808 Version 05
B=min 0.78"/20 mm
A=min 1.81"/30 mm
C=min 0.39"/10 mm
Flexible Cable
AWG
mm
2
mm
2
MIN 14 2,5 -
MAX 2 35 -
Stranded Cable
6 Nm
53 lb-in
CH 5
6 Nm
53 lb-in
CH 5
8 Nm
71 lb-in
CH 6
MAX dia. 0.31"/ø 8 mm
A
B
C
62 lb-in - 7 Nm
CH 4
8 Nm
71 lb-in
CH 6
- If present
- Se presente
- Falls vorhanden
- Si présent
- Si lo hay
8
9
7
140G-I
140G-J
DIR 1000719R0808 Version 05 - ECN000111880
Copyright © 2019 Rockwell Automation, Inc. All Rights Reserved. Printed in Italy.
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication
140G-IN093F-MU-P - July 2019
Rockwell Automation maintains current product environmental compliance information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/
sustainability-ethics/product-environmental-compliance.page
B=min 0.59"/15 mm
A=min 1.81"/30 mm
LE N G T H dia.
1 2 m m (0.47" ) 3m m
MAX dia. 0.31"/ø 8 mm
A
B
62 lb-in - 7 Nm
CH 4
1
2
1
Flexible Cable
AWG
mm
2
mm
2
MIN 14 2,5 -
MAX 2 35 -
Stranded Cable
  • Page 1 1
  • Page 2 2
  • Page 3 3

Rockwell Automation Allen-Bradley 140G-G User manual

Allen-Bradley 140G-G
Brand
Rockwell Automation
Model
Allen-Bradley 140G-G
Type
User manual

Rockwell Automation Allen-Bradley 140G-G is a multi-cable terminal lug designed to distribute power to different loads on a load side of a circuit breaker. It is not intended for use on a line side. With a maximum AWG of 2 and a maximum diameter of 0.31 inches, it can accommodate a wide range of cable sizes. The 140G-G features a screw clamp termination type for secure and reliable connections. Additionally, it has an end cap kit and a terminal cover for added protection.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents