2. PRECISION EFI
  3. Ski-Doo 900 ACE
Ski-Doo 900 ACE

PRECISION EFI Ski-Doo 900 ACE User manual

  • Hello! I'm a chat assistant familiar with the PRECISION EFI Tech Guide for the 900 ACE TURBO Blow Off Valve Kit. This document provides detailed instructions for installation, including how to remove parts and connect new components. I'm ready to answer your questions about the installation process.
  • What tools are required for the installation?
    Is it necessary to modify the charge tubes during installation?
    What should I do after disconnecting the charge tube from the turbo outlet?
TECH GUIDE
b.o.v. 900 ace turbo
PAGE|01
Unplug the battery
Loose the air intake tube clap and remove the hood.unplug the light connector and remove hood bolt Do
not forget to disconnect the front lights and the
optional lights if present.
Unplug and remove the instrument panel
1
5
3
2
remove both side panels.
4
difculty level:
easy
time estimated:
30 MINUTES
• RATCHET
• 10 MM SOCKET
• TORX T-30
TECH GUIDE
b.o.v. 900 ace turbo
PAGE|02
Connect the Blow Off Valve Kit to the turbo
outlet using the provided clamp.
Then proceed to the installation of the Map
Sensor Shim and hose supplied. Remove the
manifold absolute pressure sensor with a Torx
T-30 screwdriver
Unscrew the clamp and disconnect the charge
tube connected to the turbo outlet.
Connect the charge tube to the other end of the
Blow Off Kit using the oem clamp.
Attach the vacuum hose with the zip ties provided,
taking care not to tighten too hard so as not to
obstruct the passage.
Install the spacer between the intake manifold
and the manifold absolute pressure sensor with
the screw included in the kit, taking care to
tighten it until all the at surfaces are in
contact.
3
5
2
4
6
Important: Do not cut or modify the charge tubes; this Blow Off Valve Kit is direct-t without any
modication.
/