Troy-Bilt 31AH64Q4711 Fast Start Guide

Type
Fast Start Guide

Troy-Bilt 31AH64Q4711 is a powerful snow thrower designed to make snow removal a breeze. With its 21-inch clearing width and 12-inch intake height, it can handle even the heaviest snowfall. The 208cc engine provides ample power to throw snow up to 25 feet away, while the six forward and two reverse speeds give you precise control over the machine. The chute can be rotated 180 degrees, allowing you to throw snow in any direction. The heated handgrips and headlight make it comfortable and safe to operate, even in the darkest and coldest conditions.

Troy-Bilt 31AH64Q4711 is a powerful snow thrower designed to make snow removal a breeze. With its 21-inch clearing width and 12-inch intake height, it can handle even the heaviest snowfall. The 208cc engine provides ample power to throw snow up to 25 feet away, while the six forward and two reverse speeds give you precise control over the machine. The chute can be rotated 180 degrees, allowing you to throw snow in any direction. The heated handgrips and headlight make it comfortable and safe to operate, even in the darkest and coldest conditions.

Upper Handle
A
B
Shift Lever
Chute Control
Hex Rod
Form No. 778-11822A© 2009 31AH64Q4
Chute
Handle Knobs
Chute Base
Chute Support
Bracket
Chute Control
Head
Place shift lever A.
into F6 position.
Pivot upper handle B.
into operating
position
Tighten handle C.
knobs.
A
B
C
Place chute onto
chute base and
secure with the
hardware removed
in Step 2.
Squeeze the trigger on
the joystick and rotate
the chute by hand to
face forward.
The holes
in the rear of the
chute control head
will be facing up.
Insert the round end of
the hex rod (hole pointing
upward) as far as possible
into the chute control head.
Rotate the chute
control to
1 o’clock, so the silver
arrow on the pinion
gear faces upward.
Insert the hex end of the
rod (hole pointing upward)
into the pinion gear.
Secure the round end
of the hex rod to the
chute control head as
shown, with the cotter pin
removed in Step 2.
Remove cotter pin, wing nut A.
and hex screw from chute
control head.
Remove clevis B.
pin and bow-
tie pin from
chute support
bracket.
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Oil Fill /
Dipstick
Electric Starter
Button
Electric
Starter Outlet
Primer
Key
Throttle
Control
Choke
Control
Gas Fill
Move throttle control
into the Fast
position.
Move the choke control
into the Choke
position.
Connect power cord to A.
electric starter outlet.
Plug other end of power B.
cord into a three-prong
120-volt, grounded, AC
receptacle.
Push primer
three times.
Fill fuel tank with
clean, fresh gasoline.
Do not fill above the
base of fuel tank neck.
Check the oil level
using the dipstick.
Add oil if necessary.
(Refer to the
Operator’s Manual)
Insert the key into
the key switch
until the key snaps
into place.
Do not turn the key!
To start engine, A.
push the starter
button.
When engine B.
starts, slowly move
choke control into
the Run position.
Disconnect cord C.
from power
receptacle first and
then from snow
thrower’s outlet.
Form No. 778-11822A© 2009 31AH64Q4
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
  • Page 1 1
  • Page 2 2

Troy-Bilt 31AH64Q4711 Fast Start Guide

Type
Fast Start Guide

Troy-Bilt 31AH64Q4711 is a powerful snow thrower designed to make snow removal a breeze. With its 21-inch clearing width and 12-inch intake height, it can handle even the heaviest snowfall. The 208cc engine provides ample power to throw snow up to 25 feet away, while the six forward and two reverse speeds give you precise control over the machine. The chute can be rotated 180 degrees, allowing you to throw snow in any direction. The heated handgrips and headlight make it comfortable and safe to operate, even in the darkest and coldest conditions.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI