Davis Instruments 6620 Owner's manual

Note: Using An External Temperature Probe

with Vantage Connect®

You may use an external temperature probe (product numbers

6475 or 6477) with your wireless Vantage Connect. Just feed the

probe cable up through one of the holes in the bottom of the

shelter (using the oval split grommet provided in the Vantage

Connect hardware kit) and plug it into the cabled ISS jack. (See

page 7.) This reading will replace the Vantage Connect’s “inside

temperature” reading.

Jack for External

Temperature Probe

(or for cabled ISS)

Document 7395.211 Rev. A 12/3/13

This manual is also suitable for