Assembly Instructions: 3602-14 (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromtheceiling,includingthe
oldmountingstrap.
Fromthepartsbagremovethemountingstrapassembly.One
endofnipple(F)shouldbeattachedtomountingstrap(B)with
washerandhexnut(CandC1)inplace.Attachmountingstrap(B)
tothejunctionboxusingmountingscrews(D)andascrewdriver.
Tightensecurely.
CONNECTING THE WIRES
Haveanassistantsupportthexture’sweightwhilecompleting
thewiring.Cutawayexcesswire.Threadthexture’swires
throughcanopyloopandnipple.Attachthexture’swiresto
thepowersupplywiresfromthejunctionbox.Connectblack
to smooth/black/transparent (L) wire; white to ribbed/white/
transparent(N)wire;groundtoground(greenorcopper).Twist
theendsofthewirepairstogether,andthentwistonawire
connector. Make sure all twists are in the same direction. If there
isnogroundwire(greenorcopper)fromthejunctionbox,locate
groundscrew(E)onthemountingbracket/mountingstrapand
wrapthexture’sgroundwirearoundthegreengroundscrew(E).
Useascrewdrivertosecuregroundscrew(E)ontothemounting
bracket/mountingstrap.Tuckallwiresneatlyintothejunction
box.
FINISHING THE INSTALLATION
Unscrewscrews(L).Removediffuserandmetalring(KandM).
Avoidtouchingtheinsulationwithyourbarehands.Raisethetop
ofceilingpan(G)tomountingstrap(B).Positionnipple(F)sothat
itprotrudesthroughthecenterofceilingpan(G).Securexture
(G)tomountingstrap(A)bythreadingdecorativenut(H)onto
nipple(F).Tightensecurely.
Pushshade(I)uptoceilingpan(G).Twistscrew(A)intoceiling
pan(G).Secureinplacebytwistingshade(I)sothatthekey
holelocksontoscrew(A).Installlightbulbs(notprovided)in
accordancewiththexture’sspecications.Donotexceedthe
maximumwattage.
Placediffuser(K)intometalring(M).Raisemetalring(M)up
beneath shade (I) and twist screws (L) into each screw hole of
metalring(M).Twistuntilsecure.
Your installation is now complete. Turn on the power and test the
xture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact the
place of purchase.
Smooth / Black /
Transparent (L)
Ribbed / White /
Transparent (N)
Bare Copper / Transparent with
Green Interior / Green
White (Neutral)
Green
(Ground)
A
H
G
I
J
L
K
M
N
O
D
B
F
E
C
C1