Golden Lighting 3602-14 AB-AB Installation guide

Type
Installation guide
Assembly Instructions: 3602-14 (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromtheceiling,includingthe
oldmountingstrap.
Fromthepartsbagremovethemountingstrapassembly.One
endofnipple(F)shouldbeattachedtomountingstrap(B)with
washerandhexnut(CandC1)inplace.Attachmountingstrap(B)
tothejunctionboxusingmountingscrews(D)andascrewdriver.
Tightensecurely.
CONNECTING THE WIRES
Haveanassistantsupportthexture’sweightwhilecompleting
thewiring.Cutawayexcesswire.Threadthexture’swires
throughcanopyloopandnipple.Attachthexture’swiresto
thepowersupplywiresfromthejunctionbox.Connectblack
to smooth/black/transparent (L) wire; white to ribbed/white/
transparent(N)wire;groundtoground(greenorcopper).Twist
theendsofthewirepairstogether,andthentwistonawire
connector. Make sure all twists are in the same direction. If there
isnogroundwire(greenorcopper)fromthejunctionbox,locate
groundscrew(E)onthemountingbracket/mountingstrapand
wrapthexture’sgroundwirearoundthegreengroundscrew(E).
Useascrewdrivertosecuregroundscrew(E)ontothemounting
bracket/mountingstrap.Tuckallwiresneatlyintothejunction
box.
FINISHING THE INSTALLATION
Unscrewscrews(L).Removediffuserandmetalring(KandM).
Avoidtouchingtheinsulationwithyourbarehands.Raisethetop
ofceilingpan(G)tomountingstrap(B).Positionnipple(F)sothat
itprotrudesthroughthecenterofceilingpan(G).Securexture
(G)tomountingstrap(A)bythreadingdecorativenut(H)onto
nipple(F).Tightensecurely.
Pushshade(I)uptoceilingpan(G).Twistscrew(A)intoceiling
pan(G).Secureinplacebytwistingshade(I)sothatthekey
holelocksontoscrew(A).Installlightbulbs(notprovided)in
accordancewiththexture’sspecications.Donotexceedthe
maximumwattage.
Placediffuser(K)intometalring(M).Raisemetalring(M)up
beneath shade (I) and twist screws (L) into each screw hole of
metalring(M).Twistuntilsecure.
Your installation is now complete. Turn on the power and test the
xture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact the
place of purchase.
Smooth / Black /
Transparent (L)
Black (Hot)
Ribbed / White /
Transparent (N)
Bare Copper / Transparent with
Green Interior / Green
White (Neutral)
Green
(Ground)
A
H
G
I
J
L
K
M
N
O
D
B
F
E
C
C1
  • Page 1 1

Golden Lighting 3602-14 AB-AB Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI