2. RocketFish
  3. RF-WSBJ1

RocketFish RF-WSBJ1 Quick setup guide

  • Hello! I am an AI chatbot trained to assist you with the RocketFish RF-WSBJ1 Quick setup guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
RF-WSBJ1/RF-WSBJ2-RF-WSBJ4/RF-WSBJ6 Banana Wall Plate
QUICK SETUP GUIDE
5 Securely tighten the terminal
cap back onto the threaded
connector on the back of the
plate.
Tip: If necessary, you can use
needle-nose pliers to tighten
the cap.
6 Fix the inner plate to the electrical box with the
two long mounting screws (included).
7 Attach the outer plate to
the inner wall plate with
the two short mounting
screws (included).
8 Plug standard banana plugs into the
connectors on the front of the wall plate.
To install the banana jack wall plate:
1 Cut the speaker wire ush to the desired length.
2 Unscrew the terminal caps from the back of the
inner wall plate.
3 Slide the terminal cap onto the end of the
speaker wire, then slide one of the included
compression collars onto the wire.
White collar: 12-14 AWG speaker wire
Black collar: 16-18 AWG speaker wire
4 Firmly press the speaker wire into the back of the
connector so that the connector’s center pin
inserts into the internal strands of the wire.
Front Back
ENGLISH 10-0087
One-year limited warranty
Visit www.rocketshproducts.com for details
Contact Rocketsh: 1-800-620-2790
© 2010 BBY Solutions, Inc. All rights reserved.
Note: If mounting the wall plate without electrical box
or junction box, please follow the below steps:
Package contents:
• Mounting template
• Plastic wall anchors (2)
• Mounting screws (2 long for wall anchors)
Below parts required for installation
(not included):
• Drill and 3/8" drill bit
• Drywall saw (keyhole type saw with a narrow
blade is recommended)
• Hammer
A Position the included template on the wall where
you want to mount the HDMI wall plate. Mark
the rectangular cut-out area and mounting
screw locations (A) with a pencil and remove the
template.
B Using drywall saw (not included) cut a hole in the
drywall no bigger than the dimensions of the
cut-out area of the template.
C Using a 3/8" drill bit, drill holes in the wall at the
previously marked mounting screw locations (A).
D With a hammer gently tap the two plastic wall
anchors (included) into the holes for the
mounting screw locations (A).
Cut-out area
/