1of4
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
150W
MAX
1BULBREQUIRED
BULBNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker before installation.
Consult a licensed electrician if in doubt about installation.
Turn off power to the fixture and allow the bulbs to cool before
replacing.
Crossbar
Assembly
x1
A
Package Contents
PARTS BAG
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Fixture Body
x1
E
Crossbar Assembly Glass Panel Wiring Bulb
Table of
Contents
STEP 2 STEP 3 STEP 4 STEP 6
Fixture Body
STEP 5
Caulk
STEP 7
Alternate
Mounting
Screw
x2
B
Alternate
Mounting Screw
STEP 1
Outlet Box Screw
x2
CWire Connector
x3
D
Glass Panel
x4
F
Installation Instructions: UQL1352
www.urbanambiance.com
STEP 1
OPTION 1 OPTION 2
Included
(Pre-assembled)
Included
Standard
Mounting
Screw
Alternate
Mounting
Screw
skip to next page
1 2 3
Steps 1-3 to remove standard mounting screws
56
Steps 4-6 to reassemble with alternate mounting screws
4
2of4
STEP 2
1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting backplate to mounting screws
STEP 3
Slot
Tab
*Glass Panels
are varies
according to
purchased*
www.urbanambiance.com
3of4
*Green Ground Screw
on crossbar optional
White wire (neutral)
from outlet box
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
STEP 4
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
STEP 5
STEP 6
www.urbanambiance.com
4of4
STEP 7
Exterior Caulk
www.urbanambiance.com
/
