Page is loading ...
1of4
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
100W
MAX
1BULBREQUIRED
BULBNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker before installation.
Consult a licensed electrician if in doubt about installation.
Turn off power to the fixture and allow the bulbs to cool before
replacing.
Crossbar Assembly
x1
A
Package Contents
PARTS BAG
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Fixture Body
x1
Crossbar
Assembly Wiring
Table of
Contents
STEP 2 STEP 3
Fixture Body
STEP 4
Bulb
STEP 5
Alternate
Mounting Screw
x2
B
Alternate
Mounting Screw
STEP 1
Outlet Box Screw
x2
C
Wire Connector
x3
D
E
Exterior Caulk
STEP 6
Caulk
Installation Instructions: UQL1642
www.urbanambiance.com
2of4
STEP 1
OPTION 1 OPTION 2
Included
(Pre-assembled)
Included
Standard
Mounting
Screw
Alternate
Mounting
Screw
skip to next page
1 2 3
Steps 1-3 to remove standard mounting screws
56
Steps 4-6 to reassemble with alternate mounting screws
4
STEP 2 2
3
Step 2
Install crossbar assembly
Step3-4
Test fitting backplate to mounting screws
1
Step 1
Remove paper inside of cage
Remove
4
www.urbanambiance.com
3of4
*Green Ground Screw
on crossbar optional
White wire (neutral)
from outlet box
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
STEP 3
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
STEP 4
STEP 5
www.urbanambiance.com
4of4
STEP 6
Exterior Caulk
www.urbanambiance.com
/
