2. MORryde
  3. JP54-012

MORryde JP54-012, JP54-023 Installation guide

  • Hello! I've reviewed the installation instructions for the Quadratec Rotopax Carrier JP54-012. This document provides a step-by-step guide on how to mount the carrier to heavy-duty JK hinges and attach a Rotopax mount. It also outlines the compatible spare tire sizes and the importance of a hinge stop. I'm ready to answer your questions about this document.
  • What size spare tire is compatible in the left position?
    What size spare tire is compatible in the middle position?
    What is needed when using the middle position?
MOUNTING THE (JP54-012)
ROTOPAX CARRIER
1. Insert backer clip into one of the holes in the top heavy-duty hinge
2. Hold the backer clip in place with a finger through one of the adjacent holes
3. Insert bolt through the top hole in the carrier and thread it into the backer clip
4. Repeat the process with the lower hinge
5. Tighten both bolts to secure carrier to hinges
6. Attach rotopax mount to carrier (sold separately) - use lower position for one
gallon container or use upper position for larger containers
7. To install hinge stop remove outboard bolt on either the top or bottom hinge
bracket, line up hinge stop with hole and re-install bolt.
NOTE: Process is much easier if spare tire is removed before installation
• Maximum spare tire size compatible with the carrier in the left position is 33”
• Maximum spare tire size compatible with the carrier in the middle position is 37”. Installation of
additional hinge stop is neccessary in the middle position - Rotopax may contact tailgate if not
installed.
*Easily mounts to the Heavy-Duty JK hinges, sold separately
/