dji Phantom 3 Advanced Installation guide

Type
Installation guide

This manual is also suitable for

PHANTOM 3
Prop Guards Installation Guide
In the Box
Weight (1pc) 21 g
Angle 155.0°
Radius 131.7 mm
Installed Circumference 612 mm
Specications
Prop Guards ×4 Thread ×1 Hex Key ×1 Screws ×10
Installation
Prepare your Phantom 3, Prop Guards (4pcs), screws (8pcs),
thread and hex key.
©
2015 DJI. All Rights Reserved.
Use the hex key to remove the two outer screws under
each of the four motors.
Keep these original screws for when you are not using
Prop Guards.
©
2015 DJI. All Rights Reserved.
1
Only use the Prop Guard screws when Prop Guards are
mounted to avoid loose joints or damage to the motors.
Mount all four Prop Guards onto the Phantom 3 and
tighten the Prop Guard screws. Do not use threadlocker.
©
2015 DJI. All Rights Reserved.
2
For better protection, attach the thread so that it runs
through and under the Prop Guards.
If you have any questions about this document, please contact DJI by
sending a message to
.
Download the latest version from
http://www.dji.com/product/phantom-3
The content is subject to change.
©
2015 DJI. All Rights Reserved.
3
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

dji Phantom 3 Advanced Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI