UniGuard UM209-B User manual

Category
GPS receiver modules
Type
User manual

This manual is also suitable for

UniGuard Technology Limited
- - www.uniguardgps.com
1
GPS/GPRS/GSM Super GPS Tracker
User Manual
UM209
Attention:
UM209-B / 20000mAh / Standby / 120Days
UM209-C / 20000mAh / Standby / 240Days
UniGuard Technology Limited
- - www.uniguardgps.com
2
1 GPS Tracking System Introduction
Mini GPS tracker UM209 integrates GPS and GSM functions, which could send
vehicle location and status to mobile and Internet. It utilizes GPS and LBS double
locating. No wires connection. Place and Work. The system structure is as below:
UniGuard Technology Limited
- - www.uniguardgps.com
3
2 Product Description
2.1 Specification
Content
Specifications
Dimensions
120*65*35 mm / 120*65*48 mm
Weight
250g
Network
GSM/GPRS
Band
850/900/1800/1900Mhz
GPS chip
UBLOX-7
GSM Module
MTK6261
GPS sensitivity
-159dBm
GPS accuracy
5m
Time to First Fix
Cold status 45-120s
Warm status 35s
Hot status 1s
Battery
Chargeable 3.7V 10000mAh / 20000mAh
Standby
120Days / 240Days
Storage Temperature
-40 to 85
Operation Temperature
-20 to 55
Humidity
5%-95% non-condensing
UniGuard Technology Limited
- - www.uniguardgps.com
4
2.2 Picture and main functions:
Long standby and working time
GPS and LBS double locating
Small size for fast and easy installation
Support web and APP tracking
Suitable for vehicle/assets/container tracking
UniGuard Technology Limited
- - www.uniguardgps.com
5
3 Usage Instructions
3.1 SIM card installation
1.Open the rubber plug 2.Insert GSM SIM card 3.Close the rubber plug
(SIM card chip faces ground. If it is correctly inserted, you can hear a click sound, also
you can get SIM card out by pushing. Otherwise SIM card cannot be inserted.)
LED
Flash
On
Green LED
GSM/GPRS OK
No signal
Blue LED
GPS OK
No signal
Red LED
Off---Full Charged
On---Charging
3.2 Startup
Warn: Do not break, stab or throw the device into fire.
1. Charge the device for 8-12 hrs before usage.
2. Insert SIM card.
3. Take device outside. Pushing the button to “ON” position.
UniGuard Technology Limited
- - www.uniguardgps.com
6
4 SMS Operation Instruction
4.1 Set Admin phone number
SMS command: pw,123456,zx,0086*****
Example : pw,123456,zx,008615012404563
Reply : ‘admin OK !’
Notes : National code is needed to setup admin number.
When admin number calls device SIM, device will return current location, GPS
valid(V:A) or invalid (V:V), time, speed, battery state, ID, SIM operator, and GSM
base location information. As below :
http://maps.google.com/maps?q=22.68375%2c113.93973 V:A,2015-03-29 17:18:04
S:000km/h,Bat:6,4209800875,S25G00;p:46000, l:10352, c:4293
Remove the admin number
SMS Command : adm123456,
Reply : ADM ! A1 :
4.2 Fall alarm (Default Open)
When device falls or removed from current location, alarm message shall be sent to
admin number.
UniGuard Technology Limited
- - www.uniguardgps.com
7
4.3 Low Power Alarm (Default Open)
When device power is low near 3.7V, alarm message shall be sent to admin number.
4.4 Movement Alarm
SMS command: move123456 500
Reply: move ok
Explanation: If vehicle stops at same place for 3 to 10 mins, send this command to
device, device shall send alarm message to admin number if device moves far than
500 meters.
Note: Alarm message only works once. To activate it, you need send this command
again.
4.5 Restart Device
SMS command: RST
Device shall restart at once after receiving this command.
4.6 Restore Device
SMS command: format
Restore device shall put device settings to factory default.
UniGuard Technology Limited
- - www.uniguardgps.com
8
4.7 Set IP and Port
SMS Command : adminip123456 104.243.132.242 8000
Reply : SET IP OK ! IP :104.243.132.242#8000#
4.8 Set SIM card APN
SMS command: APN123456 APN (The second APN is SIM card APN)
Example : APN123456 CMNET
REPLY : OK ! APN :CMNET
4.9 Power Saving Mode
4.9.1 Powever Saving by Time
SMS comamnd : sleep123456 time5 (unit is minute, default 5 mins)
Reply : sleep time ok.
Explantion : If there is no any operation or alarm in 5 mins, device shall go to sleedp
mode. Close GPS, Close LED. Call or SMS command can wake up device. After wake
up, the first message is the last location data, device will send one more message when it
fetches current new location data.
4.9.2 Power Saving by Shock (Factory default)
SMS command : sleep123456 shock
Reply : sleep shock ok
Explanation : If device stay static for 5 mins, it goes to sleep mode automatically.
Close GPS, Close LED. Shock or any operation by call or SMS can wake up device.
4.9.3 Close Power Saving Mode
SMS command : sleep123456 off
UniGuard Technology Limited
- - www.uniguardgps.com
9
Reply : sleep off ok
Explanation : Device shall work continously without goign to sleed mode. Battery
consumes fast in this mode.
5 Web Tracking Platform
5.1Login www.gpspos.net to start web tracking service with your own
account
5.2 Download wechat, register a wechat account, search
GPSCARTRACK and follow, login the system with your own account.
6 Cautions
6.1 Keep the unit dry. Any liquid, i.e. rain, moisture, may destroy or damage the insi
de circu.
6.2 Don’t use & store the unit in dusty places.
6.3 Don’t put the unit in overheated or overcooled places.
6.4 Handle carefully. Don’t vibrate or shake it violently.
6.5 Clear the unit with a piece of dry cloth. Don’t clean in chemicals, detergent.
6.6 Don’t paint the unit, this may cause some foreign materials left in between the p
arts.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

UniGuard UM209-B User manual

Category
GPS receiver modules
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI