Vicon Cruiser SN673V-B User manual

HEATER KIT INSTALLATION

S660V-P

SN663V-A

1. Remove the PTZ Module to install a Heater

board.

2. Check the Power cable.

3. Assemble the Heater board to two bosses (A)

with screws.

4. Place the Heater in the slot (B).

5. Plug the Power connector to the socket of

the Heater board.

6. Heater cable should be placed away from

the Main board.

7. Assemble the PTZ Module.

24 VAC is required to use for the

camera power for stable operation with

Heater kit.

* POWER

Use Certied / Listed Class 2 power source only.

* HEATER (IF APPLICABLE)

Power Supply

Power Consumption

Heater ON

Heater OFF

24 VAC

10 W

at 59 F(15 C)

at 77 F(25 C)

50303893A

Vicon Industries Inc. 631-952-2288 800-645-9116

www.vicon-security.com

Follow these steps to install the S660-HAH heater.