Linco AM077 Installation guide

Type
Installation guide
3: Easy Softbox and Flora X™ Installation
Secure attached Easy Softbox and Flora X™ onto Lightstand Stud.
-Screw in bulbs into Ceramic Sockets on Flora X
(Flora X™ can ONLY accept LINCOInc® LED and Fluorescent Bulbs.)
-Cover Easy Softbox with diffuser. (Optional)
-Repeat Step 3 for remaining Flora X.
-
4: Boom Stand Installation
Move Boom Clamp to a center position along Boom Arm.
-Attach Boom Arm onto lightstand by securing Boom Clamp
onto Lightstand Stud.
-Attach Sand Bag onto opposite end of Boom Stud and add
counterweight.
-Secure attached Flora X™ and Easy Softbox onto Boom Arm.
-Screw in bulbs into Ceramic Sockets on Flora X
-Cover Easy Softbox with diffuser. (Optional)
-
5: Background Support Installation
5ft. Width – Use A+C Rods (10'x5')
-7.5 ft Width – Use A+B+C Rods
-10 ft Width – Use A+B+B+C Rods (5'x10')
(Attach Clamps onto Crossbar before finalizing
Installation)
-
6: Backdrop Muslin Installation
Using attached Muslin Clamps or Backdrop Holders, attach
each corner of Backdrop Muslin.
-Attach the remaining middle Muslin Clamps onto Backdrop Muslins.
(Note: This step only needs to be done once. For removal,
muslin clamps stay on muslin for easy re-installation.)
(To purchase more Muslin Clamps or Backdrop Holders,please
contact us at 562-404-0493 or email service@lincostudio.com).
-
A
B
C
B
A B CB
x 3
Softboxes
x 3
Light Heads
x 12
Bulbs
x 3
Light Stands
x 2
Backdrop Stands
x 1
Crossbar Set
x 5
Clamps
x 3
Backdrops
x 1
Boom Arm
x 1
Sand Bag
x 1
Carrying bag
PRESS
CLOCKWISE
1: Flora X™ Easy Softbox Setup
-Remove Softbox from Flat Storage Bag.
-Release Belt and Softbox will automatically pop open.
(Please use caution when releasing spring rods)
Please call 562-404-0593 or email service@lincostudio.com
if you have any questions.
Our Business Hours are 08:00-16:30 PST Monday-Friday.
LINCO INC. FLORA X™ INSTALLATION INSTRUCTIONS
(AM077 & AM143)
2: Easy Softbox and Flora X™ Installation
Place Easy Softbox™ on ground or flat surface.
-Align “X” on Flora X™ with X spring rods on
Easy Softbox
-Holding the Handle on Flora X, push
downwards and rotate clockwise.
-Be sure X spring rods click and lock into “X” on Flora X
-
2 Crossbars 3 Crossbars 4 Crossbars
  • Page 1 1

Linco AM077 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI