Gill COMPETITION TENNIS NET Operating instructions

Type
Operating instructions

This manual is also suitable for

INST 2235
12-31-2021
Copyright © 2021 by Litania Sports Group, Inc.
All rights reserved.
www.gillathletics.com
800-637-3090
Which System Do you Have ?
# 884 / 884A
Circular Post
Please go to page 2
# 885
Square Post
Please go to page 6
2235 - Tennis Net Install
- 1 -
12-31-2021
Copyright © 2021 by Litania Sports Group, Inc.
All rights reserved.
www.gillathletics.com
800-637-3090
Step 2:
2 A - Measure the total length between the 2
poles of the tennis system ( center to center )
2 B - Add 18’’ to the total length of the
measurement, cut the cable here with a cable
cutter or similar tool.
Step 3:
3 A - Strip the white coating off from the un
looped end of the top cable 10’’ to fit in the
cable clamp.
Step 4:
4 A - Route the cable through the
cable clamp to form a new loop.
4 B - Make sure the cable fits in the cable
clamp properly, exposing 2’’ of bare cable
as shown in the picture .
4 C - Tighten down the cable clamp with
both hex nuts using a 5/16’’ wrench.
2235 - Tennis Net Install
- 2 -
INST 2235
Step 1:
1 A - Lay the net down to expose both factory looped end and the un looped end.
18”
Winch post of the
Tennis System
www.gillathletics.com
800-637-3090
Step 5:
5 A - Crank the hook all the way to the top of the Winch Post with the provided handle turning clockwise.
5 B - Turn handle counter-clockwise 10 revolutions to lower hook for easier cable installation.
5 C - Attach the factory looped cable to the winch hook.
5 D - Turn Handle clockwise to raise the hook back up to expose the factory looped cable
as shown in Figure A.
Figure A
12-31-2021
Copyright © 2021 by Litania Sports Group, Inc.
All rights reserved.
2235 - Tennis Net Install
- 3 -
INST 2235
www.gillathletics.com
800-637-3090
Step 6:
Attach the formed loop ( From Step 4 ) to the post’s internal hook as shown in Figure B.
12-31-2021
Copyright © 2021 by Litania Sports Group, Inc.
All rights reserved.
Figure B
2235 - Tennis Net Install
- 4 -
INST 2235
Step 7:
7 A - Tension the net by using the provided handle at the winch post turning counter-clockwise.
7 B - If net can not reach full tension, loosen net at winch post and go back to step 3 and 4 to adjust
the cable clamp as needed.
www.gillathletics.com
800-637-3090
12-31-2021
Copyright © 2021 by Litania Sports Group, Inc.
All rights reserved.
2235 - Tennis Net Install
- 5 -
INST 2235
Step 8:
8 A - Square up the net and lace it to the post using black lacing cord
provided.Use the side grommets on the net to accept the lacing cords.
Step 9:
9 A - Install the center strap to stabilize the height of the net at the
center .
9 B - Measure the depth of the net in the center and adjust the strap to
make the net 36” at the center line of the courts.
( Center strap anchor sold separately )
www.gillathletics.com
800-637-3090
12-31-2021
Copyright © 2021 by Litania Sports Group, Inc.
All rights reserved.
2235 - Tennis Net Install
- 6 -
INST 2235
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Gill COMPETITION TENNIS NET Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI