2. OPT7
  3. 07-14
07-14

OPT7 07-14 Installation guide

  • Hello! I've reviewed the installation manual for the OPT7 White LED DRL Projector Headlights designed for the 2007-2014 Chevy Silverado. This manual provides step-by-step instructions for installing the headlights, including removing the old assembly, connecting the new one, and testing all functions. It also includes information about the included H1 halogen bulbs and the necessity of connecting the DRL to the Turn Signal. I'm ready to answer any questions you have about the installation process or product specifications.
  • What should be done before tightening all bolts and screws?
    What kind of bulbs are included with this product?
    What is the DRL headlight harness?
STEP 9
INSTALLATION
Line up the headlight housing mounting
tabs and push rearward to seat in place as
shown in step 9.
Reinstall the 10mm bolts(4x) to secure the
new headlight.
Please test all functions before tightening
all bolts and screws.
Next, please restore other components
(includes grille and ller panel ) to factory
settings.
SCAN FOR TROUBLESHOOTING
TIPS, AND MORE.
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The
Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no
responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please
seek professional assistance.
This holds a 60 days warranty starting from the order date.
NEED SUPPORT?
DISCLAIMER
WHITE
LED DRL PROJECTOR
HEADLIGHTS
2007-2014
CHEVY SILVERADO
INSTALLATION
MANUAL
PRODUCT OVERVIEW
LOW BEAM
INCLUDES
H1 HALOGEN BULB
PLUG N’ PLAY WIRE
HIGH BEAM
INCLUDES
H1 HALOGEN BULB
PLUG N’ PLAY WIRE
DRL
TURN SIGNAL
& PARKING
FRONT
SIDE-MARKER
BACK VIEW
STEP 5STEP 6
STEP 7
STEP 8
Remove the 10mm bolts (2x) from the OEM
headlight as shown in step 4.
Remove the 10mm bolt (1x) to open the
fender liner.
Release the OEM headlight and
disconnect the headlight harness.
The DRL headlight harness (Red/Black wire)
must be separately connected to the “Turn
Signal (Parking)”.
Next, please nd the last 10mm bolt (1x) and
remove it as shown in step 6.
Reattach the electrical connectors to the new headlight housing as shown in step 8.
Ensure the wires are tied up securely to ensure wires are organized and store away
from any metal surface.
INSTALLATION INSTALLATION
SCREWDRIVERS (+ AND -)
SOCKET WRENCH
SOCKETS
PANEL POPPER
Open the hood.
Please nd the 8 points marked in step 1
and remove the plastic fasteners (8x) from
the ller panel.
Remove the ller panel.
STEP 1STEP 2
STEP 3STEP 4
TOOLS NEEDED
Remove the 10mm bolts(4x) from the grille
as shown in step 2.
Remove thefront grilleby releasing (6x)
retaining clips.
DRL
BLACK(-) DRL
DRL
RED(+)
Turn
Signal
Turn
Signal
NOTE
/