2. OPT7
  3. 2007-2014
2007-2014

OPT7 2007-2014 User manual

  • Hello! I'm a chat assistant, and I've reviewed the user manual for the OPT7 White LED DRL Projector Headlights for the 2007-2014 Chevy Silverado. This document includes installation instructions, necessary tools, and connection guidance. I'm ready to answer any questions you may have about the product or its installation.
  • What should I do before tightening all bolts and screws?
    What does the DRL headlight harness (Red/Black wire) connect to?
    What is included with the low beam headlight?
STEP 9
INSTALLATION
Line up the headlight housing
mounting tabs and push rearward to
seat in place as shown in step 9.
Reinstall the 10mm bolts(4x) to secure
the new headlight.
Please test all functions before
tightening all bolts and screws.
Next, please restore other
components (includes grille and filler
panel ) to factory settings.
OPT7 Lighting is not liable for damages or personal injuries while installing this
product. The Installation Guide is intended as assistance to reduce setup time.
OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades,
please seek professional assistance.
This holds a 60 days warranty starting from the order date.
DISCLAIMER
WHITE
LED DRL PROJECTOR
HEADLIGHTS
2007-2014
CHEVY SILVERADO
INSTALLATION
MANUAL
PRODUCT OVERVIEW
LOW BEAM
INCLUDES
H1 HALOGEN BULB
PLUG N’ PLAY WIRE
HIGH BEAM
INCLUDES
H1 HALOGEN BULB
PLUG N’ PLAY WIRE
DRL
TURN SIGNAL
& PARKING
FRONT
SIDE-MARKER
BACK VIEW
STEP 5STEP 6
STEP 7
STEP 8
Remove the 10mm bolts (2x) from the
OEM headlight as shown in step 4.
Remove the 10mm bolt (1x) to open the
fender liner.
Release the OEM headlight and
disconnect the headlight harness.
The DRL headlight harness (Red/Black
wire) must be separately connected to
the “Turn Signal (Parking)”.
Next, please find the last 10mm bolt
(1x) and remove it as shown in step 6.
Reattach the electrical connectors to the new headlight housing as shown
in step 8.
Ensure the wires are tied up securely to ensure wires are organized and
store away from any metal surface.
INSTALLATION INSTALLATION
SCREWDRIVERS (+ AND -)
SOCKET WRENCH
SOCKETS
PANEL POPPER
Open the hood.
Please find the 8 points marked in
step 1 and remove the plastic
fasteners (8x) from the filler panel.
Remove the filler panel.
STEP 1STEP 2
STEP 3STEP 4
TOOLS NEEDED
Remove the 10mm bolts(4x) from the
grille as shown in step 2.
Remove thefront grilleby releasing (6x)
retaining clips.
DRL
BLACK(-) DRL
DRL
RED(+)
Turn
Signal
Turn
Signal
NOTE
/