Grisham 90009 Installation guide

Brand: Grisham

Model: 90009

Type: Installation guide

This manual is also suitable for

Adjustable Width Black Steel Security Gate

Installation

Instructions for

Adjustable Gates

(Please read all instructions carefully before starting.)

Center and level hinge side frame (A) onto mounting surface at desired location for either surface or recessed mount installation and mark hinge pilot hole locations. Proceed

to drill ¼” inch diameter pilot holes at marked locations. Reposition hinge side (A) and secure the hinges with 5/16" x 1.5" non-reversing screws provided.

2. Insert center section (C) onto the three horizontal tubes of hinge side section (A) and proceed to insert remaining lock side section (D) into horizontal center tube of section (C).

Evenly space section (C) between frame sections (A) and (D) and proceed to align lock side striker pockets (B) with the lockbox on section (D). Leave a ¼” inch reveal

between lock side frame (D) and lock side striker (B). Proceed to mark and drill the four pilot holes at designated Lock-side striker locations with 1/8” drill bit. Secure Lock-

side striker (B) with the #8 x 2” non-reversing screws. Fasten screws until seated within the tubing cavity. Finish with positioning cover caps.

4. With sections A, C, and D in proper alignment with lock side striker tube (B), then proceed to drill two 1/8” inch pilot holes at each horizontal overlap of center section (C) and

secure with two of the Phillips head self-tapping screws at each section.

5. Lock box will accept most 2-3/8 backset locksets sold in the hardware dept. (Four machine screws supplied to secure lockset striker and deadbolt to Lock box).

CENTER-SECTION FRAME(C)

HINGE-SIDE

FRAME(A)

LOCK-SIDE

STRIKER(B)

LOCK-SIDE FRAME(D)

Installation Instructions:

HARDWARE CONTENT

5/16" x 1.5" non-reversing

screw x 8

#8 x 2" non-reversing

screw x 4