ITEM NO.: 7-1620-43
7-1621-53
Fixture Body (4)
Crystal (5)
Screw (6)
OR
Stems (7)
Canopy (1)
Housing assembly (3)
ASSEMBLY INSTRUCTIONS
1.Carefully unpack and identify all parts referring to illustration for parts identification.
2.Turn the power to the installation point OFF.
3.Determine the desired height at which the pendant will be installed and select the stems.
4.Thread the wire through the stems (7). Connect the stems together and install them on the housing
assembly (3). The longer stems should be installed first on the housing assembly (3), while the shorter
stems should be closer to the canopy (1).
5.Connect the stems (7) to the loop (8).
6.Refer to the additional installation instructions included with the product for wiring and installation.
7.Install the canopy (1) to the ceiling using the ball nut (2).
8.Install the crystal (5) onto the fixture body (4) with the screw (6).
9.Restore power to the installation point and retain this sheet for future reference.
Ball Nut (2)
Loop (8)