Mira 1.1746.005 User manual

Type
User manual
1
1269096-W2-A
Mira Sport Shower Fittings (L16J)
These instructions must be left with the user
Installation and User Guide
2
1269096-W2-A
GENERAL
1. Makesurethattheshowerttingsareinstalledbyacompetentinstaller.
2. InstallationsmustcomplywithWaterRegulations(Bye-Laws,Scotland),andanyother
LocalRegulationsandBuildingRegulationsinforceatthetimeofinstallation.
3. Theshowerttingsshouldbepositionedataconvenientheightforallthefamily.Position
thettingstosprayacrossratherthantowardstheopeningofthecubicleandalsoaway
fromtheshowercontrol.Avoidlayoutswheretheshowerhosewillbesharplykinked.
Thismayreducethelifeofthehose.
4. Donottanyformofowcontrolintheoutletpipeworkiftheshowerttingsareinstalled
inconjunctionwithaproductthatrequiresthettingstoactasavent(e.g.anelectric
shower).
5. Special consideration should be given to the xing arrangements when installing
onto a dry lined, stud partition, shower cubicle or laminated panel wall structures.
Installers may wish to obtain alternative proprietary cavity xings, or choose other
options, however, these methods of xing are beyond the scope of this guide.
Note! An alternative Slide Bar Support Pack is available. Contact our Customer
Services team for more details.
6. Ahoseretainingring(integratedintothesoapdish)issuppliedtopreventtheshowerhead
from dropping below the spill over level of the bath or shower, which could lead to
contaminationfromback-siphonage.
Thepositionoftheshowerandshowerttingsmustprovideaminimumgapof25mm
betweentheshowerheadandthespilloverlevelofanybath,showertrayorbasinand
30mmbetweentheshowerheadandthespilloverlevelofanytoiletorbidet.
Zone of
BackowRisk
30 mm
Minimum
ToiletorBidet
FC5
HandBasin
FC3
BathorShower
TrayFC3
Electric
Shower
25mm
Minimum
Hose Retaining Ring (Integrated into soap dish) tted and shower ttings xed at a
suitable height preventing dirty water backow
25mmMinimum
3
1269096-W2-A
SPECIFICATION - PRESSURES
Minimummaintainedpressure:0.1bar(10kPa)
Maximummaintainedpressure:5.0bar(500kPa)
Cleaning
Manyhouseholdcleanerscontainabrasivesandchemicalsubstances,andshouldnotbeused
forcleaningplatedorplasticttings.Thesenishesshouldbecleanedwithamildwashing
updetergentorsoapsolution,andthenwipeddryusingasoftcloth.
CLEANING
4
1269096-W2-A
1. Werecommendthattheslidebarisinstalledwiththeendsush.Markthewallxing
positionsanddrilltwoholestosuitthewallxings.
Caution!Donotdrillintocablesorpipesinthewall.
Note!Foranewinstallationoptimumxingcentresare635mm.Replacement
installationxingcentresare635mmmaximum.
2. Installthewallplugsandthemountingbracketsandsecurewiththewallscrews.
Note!Checkforverticalalignmentbeforetightening.Themountingbracketsareslotted
toaidthisalignment.Thenfullytighten.
3. Installtheclampbracket(rotatethelevertohelpwiththeinstallation),thehoseretaining
ringandtheslidebarsupportstotheslidebar.
4. Makesurethatthewallscrewsareushwiththeinsideedgeofthemountingbrackets.
Fittheslidebarsupportsoverthemountingbrackets,thenadjusttheslidebarvertically
ensuring an equal length of slide bar protrudes from the top and bottom mounting bracket
(orushwiththeendoftheslidebarfornewinstallations).
5. Removetheslidebarassemblycarefully,preventinganyfurthermovementbetween
theslidebarandtheslidebarsupports.
6. Tighten the two slide bar clamping screws no more than half a turn to secure the slide
barsupportstotheslidebar.
Caution!Overtighteningthesescrewswillcausedamage.
7. Installtheslidebarassemblyontothemountingbrackets.Tightenthe2xM4screws
withthesupplied3mmhexagonalkey.
Caution!Donotforceassemblyontothemountingbrackets,re-alignaslidebarsupport
if required.
Soap Dish Installation
1. Looselysecurethetaperblockintothesoapdishwiththesoapdishscrew.
2. Insertthesoapdishassemblyintotheslidebarandtightenscrew.
Caution!Donotovertighten.
Hose and Handset Installation
1. Fitahosesealintotheconicalnutandscrewontotheoutletoftheshower.
Caution!Donotovertighten.
2. Feedthehosethroughthehoseretainingloopofthesoapdish.
3. Fitahosesealintotheconicalnutandscrewontothehandset.
Caution!Donotovertighten.
4. Placetheshowerheadassemblyintotheclampbracketassembly.
INSTALLATION
5
1269096-W2-A
1740.368
Showerhead
(White)
1740.369
Showerhead
(Chrome)
TaperBlock
1703.197
Soap Dish
1603.104
Hose(1.25m)
1740.623
ClampBracket
(White)
1740.381ComponentPack-Identied
A
632.73
Hose
Seal (x2)
1740.625
ClampBracket
(Chrome)
ForNewInstallationsCentreDistance635mm
ForRetrotInstallationsCentreDistance635mmMax.
SlideBarSupport(x2)
(includes screws)
1740.595 (White)
1740.596 (Chrome)
SlideBar
1703.204
(660 mm)
M4Screws'A'(x2)
Cap (x2)
1703.196
SlideBar
Clamping
Screw
Note!Donotovertightenthescrews
MountingPack
Components'A'
1703.194
SlideBarSupport
SlideBar
Tighten slide bar clamping
screw no more than 1/2 turn
Lever
6
1269096-W2-A
Use your thumb or a soft cloth to wipe any
limescale from the soft nozzles
Unscrew the hose from the
showerheadandtheshoweroutlet.
Inspectthehose.
Inspecting the hose
Important! Theshowerhoseshouldbeinspectedperiodicallyfordamageorinternalcollapse,
internalcollapsecanrestricttheowratefromtheshowerheadandmaycausedamagetothe
shower.Removetheshowerhosefromtheshower,inspectandreplacethehoseifnecessary.
De-scaling the Showerhead
Important!Keepingtheshowerheadcleanandfreefromlimescalewillensurethatyourshower
andshowerheadcontinuetoperformtotheirmaximum.Ablockedshowerheadcanrestrict
theowrateandmaycausedamagetoyourshower.
USER MAINTENANCE
7
1269096-W2-A
Rain +
Burst
Storm
Rain
Whenadjustingshowerspraymodesdo notforceleverasproductdamagewilloccur.
SPRAY MODES
8
1269096-W2-A
©KohlerMiraLimited,September2015
CUSTOMER SERVICE
Guarantee
Your product has the benefi t of our manufacturer's 1
year guarantee which starts from date of purchase.
Within the guarantee period we will resolve defects in
materials or workmanship, free of charge, by replacing
parts or product as we may choose.
This guarantee is in addition to your statutory
rights and is subject to the following conditions :
The product must be installed and maintained in
accordance with the instructions given in this user
guide.
Replacement under this guarantee does
not extend the original expiry date. T he guarantee
on any replacement parts or product ends at the
original expiry date.
The guarantee does not cover:
Non product faults (such as damage or
performance issues arising from incorrect
installation, improper use, inappropriate cleaning,
lack of maintenance, build up of limescale, frost
damage, corrosion, chemical attack, system
debris or blocked lters) or where no fault has
been found with the product.
Accidental or wilful damage.
Compensation for loss of use of the product or
consequential loss of any kind.
Damage or defects caused if the product is
repaired or modifi ed by persons not authorised
by us or our appointed representative.
What to do if something goes wrong
If your product does not function correctly when you
rst use it, check that it is installed and commissioned
in accordance with the instructions in this manual.
If this does not resolve the issue, contact us for help
and advice.
Mira is a registered trade mark of
Kohler Mira Limited.
The company reserves the right to alter
product specifi cations without notice.
0844 571 5000
Please note: Calls cost 7p per minute plus your phone company’s access charge.
01 531 9337
Email -
01242 282595
Email - Visit
www.mirashowers.co.uk/contactus
By Post:
Mira Customer Services Dept, Cromwell Road,
Cheltenham, Gloucestershire, GL52 5EP
To Contact Us: Eire Only
To Contact Us: UK
Helpdesk Service
Contact our Customer Service Team for
product advice, to purchase spare parts
or accessories or to request a service
visit. You can contact us via phone or
e-mail - contact details below. Please
provide your model name, power rating
(if applicable) and date of purchase.
Mira Showers Website
(www.mirashowers.co.uk)
Visit our website to register your
guarantee, download user guides,
diagnose faults, purchase our full range
of accessories and popular spares, or
request a service visit.
Spares and Accessories
We hold the largest stocks of genuine Mira
spares and accessories. Contact us for a
price or visit our website to purchase items
from our accessory range and popular spares
(Only available in the United Kingdom.)
1
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Mira 1.1746.005 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI