2. BLOTZ
  3. B06-CS-007

BLOTZ B06-CS-007 Assembly Instructions

  • Hello! I've read the instructions for the BLOTZ Cinema B06-CS-007 model. This document provides detailed step-by-step guidance for assembling the miniature cinema, starting from separating the parts from the sprue, through wall and roof assembly, to placing the sign. It also mentions the tools required, including glue and a modeling knife. I'm ready to answer your questions about this construction process
  • What type of glue is recommended?
    What other tools might I need?
    What is the purpose of the numbered layout diagram?
6mm Cinema
B06-CS-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Please refer to the final page of these instructions for a numbered layout diagram of the sprues. These numbers are used
throughout the instructions.
Take the right hand roof (1) along with the walls (2-4)
and balcony pieces (5-7) shown above from the sprue.
Glue the walls to the roof as shown. Note the wall
with the hole (3) in it is at the front, (4) is on the
right and (2) is at the back.
Glue the balcony pieces to the top of the roof as
shown. Add (6) first on the right hand side of the
picture, followed by (5) at the front and (7) at the rear.
Take the central wall (8)….
..and glue it to the assembly you have just made. The
lugs for the balcony pieces should fit easily, so if not,
check you have them in the right locations.
Take the left hand roof (9), walls (10-12) and
balcony pieces (13-15) from the sprue.
As before stick them together as shown above. (10) is
at the front, (11) is on the left and (12) at at the rear.
Then add the balcony pieces. Add (14) first (on the
left), followed by (13) at the front and (15) at the
rear.
Take the other central wall (16).
And glue that to the assembly.
The central section is formed from the pieces shown
here. (parts 17-20)
Glue them together as shown. (20) is the piece at
the back, (17) is the front and (18) is the roof. (20) is
the Cinema sign.
Take the centre section of the sign (21) along with the
right and centre portions of the building…
..then stick them together.
Add the left hand side.
Glue the whole building to its base (22).
Take the pieces shown above (parts 23-25).
Stick them together as shown.
Attach it to the front of the building using the lugs /
holes provided. Then glue the cinema sign (25) into
positon.
The finished building.
The layout of the sprues, with each piece numbered.
/