Formufit F001STE-BK-4 Operating instructions

F001STE-BK-4
Brand
Formufit
Model
F001STE-BK-4
Type
Operating instructions
Slip Sling Tee
FORMUFIT Slip Tees connect two (2) segments of PVC Pipe perpendicularly and allow one
segment of pipe to rotate or slide along another. To connect this product to PVC pipe, follow
the instructions shown below.
All rights reserved. TM, ® & Copyright © 2009-2018 FORMUFIT LC
https://formufit.com
PRODUCT INSTRUCTIONS
Line up and insert one end of a PVC
Pipe inside the ‘static’ socket end of
the Slip Tee.
Push or tap into place until the pipe
is fully seated.
Insert another PVC Pipe into the slip
end of the Slip Tee.
Push through until the pipe emerges
from the opposite end of the Slip
Tee.
1
2
3
4
Use and Adjustment
Securing
For permanent and strong connections, it is!recommended to use!PVC cement/solvent to
attach the PVC pipe and the slip tee on the static socket. Do not use PVC cement on the slip
socket if you wish for your project to rotate or slide.
You can also temporarily connect fitting by driving a self-tapping screw where the pipe and
fitting meet, or apply electrical tape over the end of the PVC pipe prior to insertion into the
static port for a temporary, yet strong connection.
All rights reserved. TM, ® & Copyright © 2009-2018 FORMUFIT LC
https://formufit.com
Use the slip tee as a sliding
mechanism that will move
along the length of the
pipe.
Use the slip tee as
support by inserting a
screw between the slip
socket and the pipe to
temporarily attach in
place.
A
B
C
  • Page 1 1
  • Page 2 2

Formufit F001STE-BK-4 Operating instructions

F001STE-BK-4
Brand
Formufit
Model
F001STE-BK-4
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents